User manual HATCO GR3SDM-0606(2)

[. . . ] GLO-RAYTM Heated Glass Merchandisers GR3SDH & GR3SDS Series Installation & Operating Manual I&W #07. 05. 146. 00 This manual contains important safety information concerning the maintenance, use and operation of this product. Failure to follow the instructions contained in this manual may result in serious injury. If you're unable to understand the contents of this manual, please bring it to the attention of your supervisor. Do not operate this equipment unless you have read and understood the contents of this manual. Este manual contiene importante información sobre seguridad concerniente al mantenimiento, uso y operación de este producto. [. . . ] Side Glass Panel Installation Model GR3SDH Standard Number or GR3SDS of Rods per Unit -27 -33 -39 -27D -33D -39D 10 pc. GR3SDM-0606 INSTALLATION LOCATION NOTE: Unit must be transported in the upright position. For proper operation and maximum performance, locate the Heated Glass Merchandisers in an area where the ambient air temperature is constant and is a minimum of 70°F (21°C). Areas which are susceptible to active air movements or currents should be avoided, i. e. , near exhaust fans or hoods and air conditioning ducts. WARNING Plug unit into a properly grounded electrical outlet of the correct voltage, size and plug configuration. If the plug and receptacle do not match, contact a qualified electrician to determine the proper voltage and size and install the proper electrical outlet. WARNING Model GR3SDS-33D, 120 volt has two circuits and each circuit has a separate power supply cord. For safe and proper operation each circuit/power cord must be plugged into a separate branch circuit rated 120 volts and a minimum of 15 amps. For safe and proper operation locate the unit indoors where the ambient air temperature is constant and is a minimum of 70°F (21°C). WARNING For safe and proper operation, the unit must be located a reasonable distance from combustible walls and materials. If safe distances are not maintained, discoloration or combustion could occur. CAUTION To avoid any injury or damage locate the unit at the proper counter height, in an area that is convenient for use. The location should be level to prevent the unit or its contents from accidentally falling, and strong enough to support the weight of the unit and food displayed. Form No. GR3SDM-0606 8 OPERATION WARNING To avoid any injury, do not allow liquids to spill onto the heated glass shelf. To avoid electrical shock or personal injury DO NOT submerge in water. WARNING For safe and proper operation do not place food product directly onto glass or hardcoat surface. CAUTION To avoid any injury, do not come in contact with the heated glass shelf while unit is in operation. The Heated Glass Merchandising Warmers main power is controlled by an ON/OFF rocker switch. (See Figure 8. ) The switch must be in the ON position for the unit to function. The hardcoat heated base can be set to any desired heating level as indicated on the control plate. The temperature range of the hardcoat heated base is from the ambient room temperature to 200°F (93°C). (See Figure 8. ) The heated glass shelf or shelves are controlled by switches that can be set to any desired heating level as indicated on the control plate. [. . . ] HATCO WILL NOT BE LIABLE, UNDER ANY CIRCUMSTANCES, FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES, INCLUDING BUT NOT LIMITED TO LABOR COSTS OR LOST PROFITS RESULTING FROM THE USE OF OR INABILITY TO USE THE PRODUCTS OR FROM THE PRODUCTS BEING INCORPORATED IN OR BECOMING A COMPONENT OF ANY OTHER PRODUCT OR GOODS. 13 Form No. GR3SDM-0606 HATCO AUTHORIZED PARTS DISTRIBUTORS ALABAMA Jones McLeod Appl. Phoenix 602-252-0402 CALIFORNIA Industrial Electric Huntington Beach 714-379-7100 INDIANA GCS Service Indianapolis IOWA Electric Motor Service Co. Davenport 319-323-1823 Goodwin Tucker Group Des Moines 515-262-9308 KENTUCKY GCS Service Louisville LOUISIANA Chandlers Parts & Service Baton Rouge 225-272-6620 MARYLAND Electric Motor Service Baltimore 410-467-8080 GCS Service Silver Spring MASSACHUSETTS Ace Service Co. , Inc. [. . . ]