User manual HATCO GR3M-0905(1)

[. . . ] GLO-RAY® Heated Glass Overshelves GR3 & GR3L Series Installation & Operating Manual I&W #07. 05. 154. 00 This manual contains important safety information concerning the maintenance, use and operation of this product. Failure to follow the instructions contained in this manual may result in serious injury. If you're unable to understand the contents of this manual, please bring it to the attention of your supervisor. Do not operate this equipment unless you have read and understood the contents of this manual. Este manual contiene importante información sobre seguridad concerniente al mantenimiento, uso y operación de este producto. [. . . ] Route flexible conduit through the pre-drilled hole and place unit on countertop. Remove the screw from each counter mount cover and lift cover to expose mounting holes. Using the mounting brackets as a template, mark the mounting holes in the countertop. NOTE: Verify legs on unit are straight and perpendicular before marking and drilling holes. Move the unit out of the way and drill 8 mounting holes (4 for each side). Drill appropriate sized holes based on fastener size (fastener not supplied). NOTE: If mounting to a wooden countertop, use #10 wood screw (length will depend on countertop thickness). For other countertop materials, drill holes through countertop and secure with bolts and nuts. Units mounted to a metal surface may require a backing plate installed to the underside of the surface in order to increase unit stability (backing plate not supplied). CAUTION Use of excessive force when tightening mounting screws may damage unit or countertop. NOTE: Hatco recommends a qualified electrician connect the appropriate electrical power source to the Remote Control Box. Refer to SPECIFICATIONS WIRING DIAGRAM, or the unit identification plate for specific model watt and amp ratings. Connect incoming power supply to the wire leads inside the Remote Control Box. Wire leads are factory attached to the Ground Fault Circuit Interrupt (GFCI) switch. 10. Route wires located in the Flexible Conduit through knock outs located on either end of the Remote Control Box. 12. Connect heating unit and lights by attaching the Flexible Conduit wires to the terminal block located inside the Remote Control Box. (See WIRING DIAGRAM for details. ) Screw (Not Supplied) Mounting Bracket Conduit Hole Top View 1. 5" (38 mm) Counter Mount Cover Flexible Conduit 2" (51 mm) 11. 5" (292 mm) Mounting Template Nut (Not Supplied) Figure 3. GR3M-0905 6 INSTALLATION REMOTE MOUNTED CONTROL BOX (RMB) Remote mounted control box should be installed by a qualified electrician. NOTE: When mounting the remote mounted control box insure space is available to access the GFCI reset button. CAUTION The Remote Mounted Control Box must be installed outside of the heat zone. Locating the control box inside the heat zone will cause the switches to overheat, malfunction, and fail. GR3M-0905 OPERATION WARNING To avoid any injury, do not allow liquids to spill onto the Heated Glass Overshelf. [. . . ] HATCO WILL NOT BE LIABLE, UNDER ANY CIRCUMSTANCES, FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES, INCLUDING BUT NOT LIMITED TO LABOR COSTS OR LOST PROFITS RESULTING FROM THE USE OF OR INABILITY TO USE THE PRODUCTS OR FROM THE PRODUCTS BEING INCORPORATED IN OR BECOMING A COMPONENT OF ANY OTHER PRODUCT OR GOODS. 11 Form No. GR3M-0905 HATCO AUTHORIZED PARTS DISTRIBUTORS ALABAMA Jones McLeod Appl. Phoenix 602-252-0402 CALIFORNIA Industrial Electric Huntington Beach 714-379-7100 INDIANA GCS Service Indianapolis IOWA Electric Motor Service Co. Davenport 319-323-1823 Goodwin Tucker Group Des Moines 515-262-9308 KENTUCKY GCS Service Louisville LOUISIANA Chandlers Parts & Service Baton Rouge 225-272-6620 MARYLAND Electric Motor Service Baltimore 410-467-8080 GCS Service Silver Spring MASSACHUSETTS Ace Service Co. , Inc. [. . . ]