User manual HATCO GR2S-2BWM-0203

[. . . ] GLO-RAY® Designer Heated Shelf & Buffet Warmer GR2S & GR2BW Series Installation & Operating Manual I&W #07. 05. 079. 00 This manual contains important safety information concerning the maintenance, use and operation of this product. Failure to follow the instructions contained in this manual may result in serious injury. If you are unable to understand the contents of this manual, please bring it to the attention of your supervisor. Do not operate this equipment unless you have read and understood the contents of this manual. Este manual contiene importante información sobre seguridad concerniente al mantenimiento, uso y operación de este producto. [. . . ] Care should be taken when unpacking shipping carton to avoid damage to unit and components enclosed. Remove the unit from the carton and lay it upside down on the cardboard. NOTE: On GR2BW models, make sure to lay unit on the side without the control. Place a screw through each rubber foot with the screw head recessed in the center of the hole. Install one rubber foot and screw into each corner hole on base and tighten securely. CAUTION The National Sanitation Foundation (NSF) requires that GR2S/GR2BW Series units over 36" (91 cm) in length or weighing more than 80 lbs. If this unit cannot be sealed at the point of use, 4" (10 cm) legs are included to allow for proper cleaning access below unit. Installing Rubber Feet BREATH PROTECTOR(S) GR2BW models use acrylic breath protector(s) that shield the food while allowing easy access to the food product. Specially designed housings and mounting hardware make installation simple. NOTE: Remove protective paper from acrylic surfaces before mounting breath protector(s). Position the acrylic breath protector(s) side with holes into the slotted channel. Install thumbscrews into channel, through acrylic and then tighten screws until snug. Installing Breath Protector LOCATION CAUTION Locate the unit at the proper counter height, in an area that is convenient for use. The location should be level to prevent the cabinet or its contents from accidentally falling, and strong enough to support the weight of the unit and food. WARNING For safe and proper operation, the unit must be located a reasonable distance from combustible walls and materials. If safe distances are not maintained, discoloration or combustion could occur. For safe and proper operation locate the unit indoors where the ambient air temperature is constant and is a minimum of 70°F (21°C). Form No. GR2S/2BWM-0203 6 OPERATION ALL MODELS CAUTION Some exterior surfaces on the unit will get hot. Plug unit into an electrical outlet of the correct voltage, size and plug configuration. WARNING To prevent any injury or damage to the unit do not pull unit by power cord. WARNING For safe and proper operation do not place food product directly onto hardcoat surface. Food product must be wrapped, boxed or on a food pan. OFF ON ON/OFF Toggle Switch 80 F 28 C 200 F 93 C HATCO CORPORATION, Milwaukee, WI Indicator Light Thermostat Control Figure 6. [. . . ] Hatco will not accept the return of any Product without prior written approval from Hatco, and all such approved returns shall be made at Buyer's sole expense. HATCO WILL NOT BE LIABLE, UNDER ANY CIRCUMSTANCES, FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES, INCLUDING BUT NOT LIMITED TO LABOR COSTS OR LOST PROFITS RESULTING FROM THE USE OF OR INABILITY TO USE THE PRODUCTS OR FROM THE PRODUCTS BEING INCORPORATED IN OR BECOMING A COMPONENT OF ANY OTHER PRODUCT OR GOODS. Form No. GR2S/2BWM-0203 HATCO AUTHORIZED PARTS DISTRIBUTORS ALABAMA Jones McLeod Appl. Phoenix 602-252-0402 CALIFORNIA Industrial Electric Huntington Beach 714-379-7100 IOWA Electric Motor Service Co. [. . . ]