User manual HATCO GR2AM-0601

[. . . ] GLO-RAY ® Designer Infrared Foodwarmers GR2A & GR2AH Series Installation & Operating Manual I&W # 07. 05. 115. 00 This manual contains important safety information concerning the maintenance, use and operation of this product. Failure to follow the instructions contained in this manual may result in serious injury. If you are unable to understand the contents of this manual, please bring it to the attention of your supervisor. Do not operate this equipment unless you have read and understood the contents of this manual. Este manual contiene importante información sobre seguridad concerniente al mantenimiento, uso y operación de este producto. [. . . ] GR2AM-0601 INSTALLATION LOCATION CAUTION Locate the unit at the proper counter height, in an area that is convenient for use. The location should be level to prevent the unit or its contents from accidentally falling, and strong enough to support the weight of the unit and food displayed. WARNING For safe and proper operation, the unit must be located a reasonable distance from combustible walls and materials. If safe distances are not maintained, discoloration or combustion could occur. WARNING Do not install standard wattage foodwarmer (GR2A & GR2AL Series) less than 17" (43 cm) above nonmetallic surface. Do not install high wattage foodwarmer (GR2AH Series) less than 20" (51 cm) above nonmetallic surface. Do not install high wattage foodwarmer (GR2AHL Series) less than 22" (56 cm) above nonmetallic surface. Do not install standard wattage, dual foodwarmer (GR2A-XXD Series) less than 27" (69 cm) above nonmetallic surface. Do not install high wattage, dual foodwarmer (GR2AH-XXD & GR2AHL-XXD Series) less than 32" (81 cm) above nonmetallic surface. Install all Designer foodwarmers so there is a minimum distance of 6" (15 cm) from a nonmetallic wall or adjacent surface. CAUTION Do not add a decorative soffit to hide a pass-through mounted Glo-Ray Foodwarmer. CAUTION All electrical connections must be in accordance with local electrical codes and any other applicable codes. PASS THROUGH If pass-through area is 12" to 16" (31 to 41 cm) wide, the standard wattage or high wattage single unit can be used. For an 18" to 24" (46 to 61 cm) wide pass-through area, a dual unit in either standard or high wattage is recommended. Dual units must always have a minimum spacing of 3" (8 cm) between warmers. CAUTION Damage to countertop material such as Corian® and similar products caused by heat generated from Hatco equipment is not covered under the Hatco warranty. Contact the manufacturer of the base material for application information. 10-14" (25- 36 cm) Standard Watt 14-18" (36-46 cm) High Watt 18"-21" (46-53 cm) 12"-14" (30-36 cm) 14"-16" (36-41 cm) 18" or 24" (46-61 cm) Figure 3. GR2AM-0601 12 11-14" (28- 36 cm) High Watt 9" (23 cm) 8-12" (20- 30 cm) Standard Watt 9" (23 cm) INSTALLATION ALL MODELS Glo-Ray Designer Infrared Foodwarmers are shipped with most components pre-assembled. Optional non-adjustable tubular stands (10", 12" and 16") are available from the factory. Care should be taken when unpacking shipping carton to avoid damage to unit and components enclosed. 15" 6" 3" 6" Dual With 3" Spacer 18" ASSEMBLY NOTE: It is recommended that at least two people assist in the assembly/installation of the unit. Remove the unit from the carton and lay it upside down on the cardboard. Place the stand onto the unit with the exposed channel facing outward. [. . . ] Hatco reserves the right to accept or reject any such claim in whole or in part. Hatco will not accept the return of any Product without prior written approval from Hatco, and all such approved returns shall be made at Buyer's sole expense. HATCO WILL NOT BE LIABLE, UNDER ANY CIRCUMSTANCES, FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES, INCLUDING BUT NOT LIMITED TO LABOR COSTS OR LOST PROFITS RESULTING FROM THE USE OF OR INABILITY TO USE THE PRODUCTS OR FROM THE PRODUCTS BEING INCORPORATED IN OR BECOMING A COMPONENT OF ANY OTHER PRODUCT OR GOODS. Form No. GR2AM-0601 HATCO AUTHORIZED PARTS DISTRIBUTORS ALABAMA Jones McLeod Appl. [. . . ]