User manual HATCO GLO-RAY

[. . . ] Cualquier falla en el seguimiento de las instrucciones contenidas en este manual puede resultar en un serio daño. Si usted no puede entender el contenido de este manual por favor pregunte a su supervisor. No opere este equipo al menos que haya leído y comprendido el contenido de este manual. CONTENTS Introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Model Descriptions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Model WFST-1R . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Model WFST-1X & WFST-2X . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Electrical Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Electrical Rating Chart. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Plug Configurations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Cord Location . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Dimensions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Installation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Door Handles . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Floor Sheet . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Display Racks . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Legs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Stacking Kit. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Location . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Accessories. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 4" (10 cm) Adjustable Legs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Bun Pan . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Display Racks . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Solid Tray Inserts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Merchandising Decal Signs/Graphics. . . . . . . . . . . . . . . . . . 6 Reservoir Auto-Fill . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Food Holding Guide . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Operation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Removing the Rotisserie Rack For Cleaning. . . . . . . 8 Replacing the Rotisserie Rack . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Draining the Reservoir . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Lubricating The Blower Motor . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Rotisserie Chain Adjustment. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Removing Lime & Mineral Deposits. . . . . . . . . . . . . . . . . . . 9 Display Light Bulb Replacement. . . . . . . . . . . . . . . . . . . . . . . . . 9 Warranty. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Authorized Part Distributors . . . . . . . . . . . . . . . . . . Back Cover IMPORTANT OWNER INFORMATION Record the model number, serial number (located on the back of the unit), voltage and purchase date of your Flav-R-Savor® Large Capacity Merchandising Cabinet in the spaces below. Please have this information available when calling Hatco for service assistance. [. . . ] Be sure the unit is mounted on a structure of suitable strength to support the double units and the food displayed. Install the four 6" (15 cm) stainless steel legs into the base frame, tighten securely. If the frame is not level or rocking occurs, the bottom of each leg can be adjusted to correct the condition. Remove the four top cover screws from the painted cover and position the top stacking brackets on the unit. Carefully position the top unit onto the bottom unit inside the stack support brackets. Figure 6. GLO-RAY LOCATION Locate the Display Cabinet at the proper counter height, in an area that is convenient for use. The location should be level to prevent the cabinet or its contents from accidentally falling, and strong enough to support the weight of the unit and the food displayed. If laid on its side, all glass surfaces must be secured with tape, and water must be drained from the unit. (See draining instructions. ) WARNING For safe and proper operation, the Display Cabinet must be located a reasonable distance from combustible walls and materials. If safe distances are not maintained, discoloration or combustion could occur. WARNING Some exterior surfaces on the Display Cabinet will get hot. Use caution when touching these areas to avoid injury. ACCESSORIES 4" (10 cm) ADJUSTABLE LEGS To install the 4" (10 cm) appliance legs, place the unit on its side. To preserve the bright finish of the Flav-R-Savor, it is recommended that the exterior and interior surfaces be wiped daily with a damp cloth. The left rotisserie support and air distribution duct are removable for cleaning. Stubborn stains may be removed with a good stainless steel cleaner or a non-abrasive cleaner. Hard to reach areas should be cleaned with a small brush and mild soap. DRAINING THE RESERVOIR WARNING: To avoid any injury, turn the power off to the unit and allow to cool before draining. NOTE: The drain hose assembly is located inside the cabinet at the right front corner. It is recommended that the Flav-R-Savor water reservoir be drained prior to moving the cabinet and required after removing lime or mineral deposits from the water reservoir. To drain the reservoir insert the drain fitting with hose into the water outlet, located on the ceiling of the cabinet. Once the fitting is installed, water will begin to drain from the hose. Once the unit has finished draining, the drain assembly can be removed by pressing the release tab and gently pulling the drain line out. CAUTION: Abrasive cleaners could scratch the finish of your Flav-R-Savor Large Capacity Holding and Display Cabinet. Clean the glass sides using a common glass cleaner. REMOVING THE ROTISSERIE RACK FOR CLEANING (MODEL WFST-1R) 1. Lift left side of the rotisserie rack and move slightly to left to disengage drive mechanism. [. . . ] Without limiting the generality of the foregoing, SUCH WARRANTIES DO NOT COVER: Coated incandescent light bulbs, fluorescent lamps, lamp warmer heat bulbs, glass components or Product failure in booster tank and fin tube heat exchanger caused by liming, sediment buildup, chemical attack or freezing in tanks, Product misuse, tampering or misapplication, improper installation, application of improper voltage, or recalibration of thermostats or high limit switches. LIMITATION OF REMEDIES AND DAMAGES Hatco's liability and Buyer's exclusive remedy hereunder will be limited solely, at Hatco's option, to repair or replacement by a Hatco-authorized service agency (other than where Buyer is located outside of the United States or Canada, in which case Hatco's liability and Buyer's exclusive remedy hereunder will be limited solely to replacement of part under warranty) with respect to any claim made within the applicable warranty period referred to above. Without limiting the generality of the foregoing, all portable Products (as defined in N. S. F. 4-4. 28. 4) shall be delivered by Buyer, at its sole expense, to the nearest Hatco-authorized service agency for replacement or repair. [. . . ]