User manual HASBRO ZORRO

[. . . ] If the AR-151/ZORRO is used with the facsimile expansion kit AR-FX3 or if it is an AR-F152, please refer to the attached Declaration of Conformity on the rear inside cover page. 1-12) 2 Light ({) and dark (}) keys and exposure indicators ) Use to adjust the MANUAL (=) or PHOTO ( exposure level. 1-22) 4 Copy ratio selector key and copy ratio indicators Use to sequentially select preset reduction/ enlargement copy ratios. 1-14) 7 Display Displays the specified copy quantity, zoom copy ratio, user program code, and error code. [. . . ] (When copying from the original table in the duplex mode, only A4 size paper can be used. Set the number of copies using the two copy quantity (<, <) keys. To display the number of copies made in a continuous run, press the left copy quantity key. To verify a zoom setting without changing the zoom ratio, press and hold down the copy ratio display (%) key. When the key is released, the display will return to the copy quantity display. To reset the ratio to 100%, press the copy ratio selector key repeatedly until the 100% indicator lights up. When a zoom (N or L) key is pressed, the ZOOM indicator will light up and the zoom ratio will be displayed in the display. In order to quickly change the zoom ratio, press and hold down the (N or L) key. the displayed setting will stop on any preset reduction or enlargement setting. To further reduce or raise the zoom ratio, firstly release the key and then press and hold down. Set the number of copies using the copy quantity (<, <) keys and press the print ( ) key. The auto power shut-off mode saves more power than the preheat mode but requires a longer time before starting copying. Then make desired copier selections and press the print ( ) key using the normal copying procedure. To exit from the auto power shut-off mode, press the print ( ) key or any key onthe operation panel for facsimile or place any originals in the SPF. (When the print ( ) key is pressed one to exit the auto power shut off mode, copying will not start) (AR-F152). Auto clear (page 1-19) The copier returns to the initial settings a preset amount of time after the last copy is made. Press and hold down the exposure mode selector key for approximately 5 seconds. The exposure indicator marked "1" will light up, indicating the toner save mode is selected. To return to the standard mode, repeat the procedure but use the dark (}) key to select exposure level "5" in step 3. The user programs allow the parameters of certain functions to be set, changed, or cancelled as desired. Setting the power save modes and auto clear time, and stream feeding mode. Press and hold down the light ({) and dark (}) keys simultaneously for more than 5 seconds until all the alarm indicators (q, t, s and p ) blink and "­ ­" appears in the display. [. . . ] If it is difficult, remove the misfed original from under the feeding roller. A number may appear in the display after a minus sign, indicating the number of the originals that must be returned to the document feeder tray. If any problem occurs, check the list below before contacting the Sharp Service Center. If the copier is not used for a long time, remove the paper from the paper tray and store it in its wrapper in a dry location. [. . . ]