User manual HASBRO ZOIDS SAICURITE

[. . . ] â· When the unit is not used for a long time, for example for consecutive holidays, turn the power switch off and remove the power cord from the outlet. â· When moving the unit, be sure to turn the power switch off and remove the power cord from the outlet. â· Do not cover the unit with a dust cover, cloth or plastic film while the power is on. â· Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. [. . . ] When copying onto A4 paper or a large size, pull out the paper output tray extension. Do not insert paper in the single bypass when a copy job from the paper tray is in progress. If you use the unit in a country other than the country where the unit was purchased, you will need to make sure that your local power supply is compatible with your model. If you plug the unit into an incompatible power supply, irreparable damage to the unit will result. Insert the attached power cord into the power cord socket at the rear of the unit. Turn the power switch on the left side of the unit to the "ON" position. The start ( ) indicator will light up and other indicators which show the initial settings of the operation panel will also light up to indicate the ready condition. The unit will enter a power save mode once the set time has elapsed without any unit operation. The unit will return to the initial settings a preset amount of time after the end of copy or scanning job. About the scan head The scan head lamp remains on constantly when the unit is in the ready condition (when the start ( ) indicator is illuminated). The unit adjusts the scan head lamp periodically to maintain copying quality. Also, if level 4 is selected, the two righthandmost indicators for that level will light up simultaneously. Three preset reduction ratios and two enlargement ratios can be selected. The zoom function enables copy ratio selection from 25% to 400% in 1% increments. Use the copy ratio selector key and/or ZOOM ( select the desired copy ratio. To verify a zoom setting without changing the zoom ratio, press and hold down the copy ratio display (%) key. When the key is released, the display will return to the copy quantity display. â· To reset the ratio to 100%, press the copy ratio selector key repeatedly until the 100% indicator lights up. To move beyond these ratios, release the key and then press and hold it down again. To select a zoom ratio: When a ZOOM ( or ) key is pressed, the ZOOM indicator will light up and the zoom ratio will be displayed in the display. Use the left copy quantity ( ) key to select a user program number (1: auto clear time, 2: preheat mode, 3: auto power shut-off timer, 5: auto power shut-off mode 6: resolution of AUTO & MANUAL mode). The entered program number will be steadily lit and the currently selected parameter number for the program will blink on the right side of the display. [. . . ] A: Misfeed in the paper feed area Gently remove the misfed paper from the paper feed area as shown in the illustration. When the misfeed ( ) indicator blinks, and the misfed paper is not seen from the paper feed area, pull out the paper tray and remove the misfed paper. Do not touch the photoconductive drum (green portion) when removing the misfed paper. Close the side cover by pressing the round projections near the side cover open button. [. . . ]