User manual HASBRO ZOIDS METALRHIMOS

[. . . ] Note that if more than 6 seconds* is required to clear the data, the message will be displayed until data clearing is finished. Be changed with the key operator program, "MESSAGE TIME SETTING". NOTES Using the printer function When printing a normal print job in printer mode, the image data is automatically cleared from memory and the peripheral hard disk after printing is finished. Please note, however, that when the job retention function (see page 5-2 of the "Operation Manual for printer" on the "PRINTER UTILITIES" CD-ROM) is used for printing, the data is retained on the peripheral hard disk. [. . . ] The retained data can be erased from the Print hold job list display of the touch panel (see page 5-2 of the "Operation Manual for printer" on the "PRINTER UTILITIES" CD-ROM). When the security kit is installed, the "DELETE THE PRINT HOLD DATA" key operator program on page 6-5 of the "Operation Manual for printer" cannot be used. To erase all retained data, use the "CLEAR ALL MEMORY" (page 4 of this manual). If the unit power is turned off while image data is being cleared from the hard disk drive or before jobs are finished, the data may not be completely erased. If you do not wish to leave partially cleared data when the power is turned off, it is recommended that you use the key operator program, "CLEAR ALL MEMORY" (page 4 of this manual), to complete data clearing before turning off the power. To ensure that the data security function of the machine provides maximum security, observe the following: The key operator plays an important role in maintaining security. Exercise appropriate care in selecting the person that will assume the job of key operator. Always keep "POWER UP AUTO CLEAR" (page 5 of this manual) enabled. Be sure to change the key operator code immediately each time a new person takes over as key operator. Change the key operator code on a regular basis (at least once every 60 days). When the [CANCEL] key is touched, the key operator code entry screen appears. Note that data that has already been cleared at the time you enter your 5-digit key operator code will not be restored. When data clearing is canceled, the machine will power off temporarily and then automatically power back on. The repeat count for "CLEAR ALL MEMORY" can be set to any number from 1 to 7. Touch the [NUMBER OF TIMES CLEAR ALL MEMORY PROGRAM IS REPEATED] key, and set the desired number of times with the or key. (See "About the repeat count setting" on page 5 of this manual. About the repeat count setting When the repeat count is increased to enhance the security function, the time required for data clearing will increase. It is recommended that "NUMBER OF TIMES CLEAR ALL MEMORY PROGRAM IS REPEATED" be set to the most suitable number for your conditions of use. This program automatically clears all data stored in the unit when the main switch is turned on. To enable "POWER UP AUTO CLEAR", touch the checkbox so that a checkmark appears and then touch the [OK] key. [. . . ] This program automatically clears all data stored in the unit when the main switch is turned on. To enable "POWER UP AUTO CLEAR", touch the checkbox so that a checkmark appears and then touch the [OK] key. NOTE If you wish to cancel after data clearing has begun See the explanations in "Clear screen 2" and "NOTE" in "CLEAR ALL MEMORY" on page 4 of this manual. This program is used to disable printing of the following lists, which are printed using "LIST PRINT" in the user settings (page 2-14 of the "Operation Manual (for general information and copier operation)"). [. . . ]