User manual HASBRO WUZZLES

[. . . ] The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured red. Ensure that your equipment is connected correctly-if you are in any doubt consult a qualified electrician. Please contact your dealer for service if required or contact Sharp Corporation of Australia on 1 300 13 50 22 for referral to your nearest Sharp authorized Service Center. WARNING ­ FCC Regulations state that any unauthorized changes or modifications to this equipment not expressly approved by the manufacturer could void the user's authority to operate this equipment. [. . . ] If you are using Windows, you can use the Adjustment Pattern on the accompanying CD-ROM. (When the screen displays an entirely dark image, the automatic screen adjustment may be disabled. When making an automatic adjustment, be sure to either use the Adjustment Pattern or try displaying an image that makes the entire screen very bright. After completing the adjustments, press the computer's [Esc] key to exit the Adjustment Program. Note: - If your computer's display mode is set to 65K colors, you may see the different color levels in each color pattern or the gray scale may look colored. If you are using Windows, open the Adjustment Pattern on the accompanying CD-ROM. 18) If your system is not Windows, you can not use the Adjustment Pattern. Therefore display an image that makes the entire screen light and adjust it through checking visually its actual tone. This chapter provides the procedure how to adjust the screen by using Adjustment Pattern (for Windows) - To choose a menu option: button - To go to the next menu: MENU button CLOCK The figure below demonstrates how to adjust so that vertical flicker noise is not emitted. Vertical flicker noise PHASE The figure below demonstrates how to adjust so that horizontal flicker noise is not emitted. ( buttons) Note: - Adjustments to PHASE should be made only after CLOCK has been correctly set. ) Note: - As the resolution input for other than 400 lines is done automatically, there is no need to set it. Notes: - Depending on the resolution of the input signal, even if menu options can be selected, the display may not change. - To choose a menu option: button - When adjustment complete: MENU button OSD After selecting [OSD] , press the button. OSD H-POSITION (OSD horizontal position) The position of the OSD display can be moved to the left and right. ( buttons) OSD V-POSITION (OSD vertical position) The position of the OSD display can be moved buttons) up and down. ON: Orientation for long height display OFF: Orientation for long width display LANGUAGE Messages displayed on the screen and OSD Menu contents can be changed to the following languages. EXPAND (Screen expansion) For display modes of less than 1280 X 1024 pixels, the display can be expanded if desired. ( buttons) OFF: Expansion off ON1: Using the fixed aspect ratio, the entire screen is enlarged. Note: - If a resolution of 1280 X 1024 pixels cannot be achieved even after expansion is attempted, the screen's perimeter will display black. If you are using Windows, open the Adjustment Pattern on the accompanying CD-ROM. 18) If your system is not Windows, you can not use the Adjustment Pattern. [. . . ] When the message indicating installation is finished is displayed, click [Next]. When the message indicating installation is finished is displayed, click on [Restart]. Aktivieren Sie [Display a list of all the drivers in a specific location, so you can select the driver you want], und klicken Sie auf [Next]. Klicken Sie auf [Display a list of all the drivers in a specific location, so you can select the driver you want. [. . . ]