User manual HASBRO WORM WRESTLE

[. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Use nothing but the included cables and AC cord to insure compliance with FCC regulation for Class B computing equipment. Operation is subject to the following conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undersized operation. [. . . ] In this case, change the settings so that only the monitor is displaying. (If the set-up information has already been installed, so too has the profile, and there is no need to install it. Click on [General] and from [Compatibility] select [Apply the new display setting without restarting], then click on [Color Management]. Choose the color profile that you would like to install, and click on [Add]. Information about the ColorSync profile (MacOS) About the ColorSync profile ColorSync is the Apple Corporation's color management system and is a function that enables color resolution to be realized when used with a compatible application. Turning the power off If the monitor is not going to be used for a long period of time, be sure to unplug it from the AC outlet. Turn off device to which monitor is connected Turn monitor off In addition, it is necessary to have PC Exchange or File Exchange installed in your system. - Depending on the type of computer or OS, command names and methods may differ. Please follow the computer's own operation manual while reading this. Copy the profile to be used from the Mac folder on the Utility Disk to the ColorSync profile folder located within the system folder. Using the ColorSync on the control panel, choose the profile to be used. - If your computer's display mode is set to 65K colors, you may see the different color levels in each color pattern or the gray scale may look colored. If using Windows, you can open and use the Adjustment Pattern on the accompanying Utility Disk. CLOCK The figure below demonstrates how to adjust so that buttons) vertical flicker noise is not emitted. PHASE The figure below demonstrates how to adjust so that buttons) horizontal flicker noise is not emitted. ( Note: - Adjustments to PHASE should be made only after CLOCK has been correctly set. (ADJUSTMENT GAIN CONTROL WHITE BALANCE MODE SELECT OSD Menu disappears) Notes: - The OSD Menu automatically disappears approximately 30 seconds after the last command. - This explanation is based on using the Adjustment Pattern (for Windows) to make adjustments. H-POS (horizontal positioning) and V-POS (vertical positioning) To center the screen image within the boundaries of the screen, adjust the left-right (H-POS) values and the up-down (V-POS) values. - To choose a menu option: SELECT button - To go to the next menu: MENU button - To choose a menu option: SELECT button - To go to the next menu: MENU button If you are not using the Adjustment Pattern it is necessary to have an area of 5 mm x 5 mm of white displayed, and if not adjustments may not be possible. (In such case , [OUT OF ADJUST] will appear and setting values remain unchanged. ) - If the signal coming from the computer is composite sync or sync on green, automatic adjustment cannot be performed. [. . . ] Aktivieren Sie [Display a list of all the drivers in a specific location, so you can select the driver you want], und klicken Sie auf [Next]. Klicken Sie auf [Display a list of all the drivers in a specific location, so you can select the driver you want. Aktivieren Sie [Display a list of the known drivers for this device so that I can choose a specific driver], und klicken Sie auf [Next]. Aktivieren Sie [Display a list of all the drivers in a specific location, so you can select the driver you want. [. . . ]