User manual HASBRO WHO WANTS TO BE A MILLIONAIRE HANDHELD 2000

[. . . ] ADVERSEL USYNLIG LASERSTR LING NSTRDEKSEL PNES OG SIKKERHEDSL S BRYTES. LNING N R DENNA DEL R PPNAD OCH GE FFNET UND VORSICHT UNSICHTBARE LASERSTRAHLUNG WENN ABDECKUNG STRAHL AUSSETZEN. NICHT DEM LASERSTR LING SIKKERHEDSAFBRYDERE ER ADVARSEL USYNLIGFUNKTION. AVATTAESSA JA SUOJALUKITUS OHITETTAESSA OLET ALTTIINA N KYM T NT LASERS TEILYLLE. [. . . ] Also, if level 4 is selected, the two right-handmost indicators for that level will light up simultaneously. 13 EXPOSURE ADJUSTMENT/PHOTO COPYING 4 Set the number of copies using the copy quantity ( ( ) key. , ) keys and press the print 3 Making copies REDUCTION/ENLARGEMENT/ZOOM Three preset reduction ratios and two enlargement ratios can be selected. The zoom function enables copy ratio selection from 50% to 200% in 1% increments. Do not let copies stack up. Print face TWO-SIDED COPYING Two-sided copying can be made on this copier using the manual bypass. Example: The following two originals will be copied onto two sides of copy paper. Face up or face down Face up First original Second original Face down 15 TWO-SIDED COPYING 1 Place the first original on the original table and make a copy. The first copy can be made using either the paper tray or the manual bypass. 3 Making copies 2 Replace the first original with the second original on the original table and close the original cover. Make sure that the first and second originals are oriented in the same way on the original table. 3 For tablet binding, turn the first copy over left to right as shown below. For booklet binding, turn the first copy over top to bottom (not shown). Copying will begin automatically. 16 4 SPECIAL FUNCTIONS This chapter describes the special functions of this copier. Use these functions as needed. DESCRIPTION OF SPECIAL FUNCTIONS High image quality mode This mode improves copy image quality by increasing copy density with a slight increase of toner consumption. Power save modes (page 18) The copier has two power save modes of operation: preheat mode and auto power shut-off mode. q Preheat mode When the copier enters the preheat mode, the power save ( ) indicator will light up and other indicators will remain on or off as before. In this condition, the fuser in the copier is maintained at a lower heat level, thereby saving power. To copy from the preheat mode, make desired copier selections and press the print ( ) key using the normal copying procedure. q During long copy run of a dark original, the ready ( ) indicator may blink, the indicator light up, and the copier stop, even though toner is left. The copier will feed toner up to 2 minutes and then the ready ( ) indicator will light up. Then, push gently on both sides of the front cover to open the cover. 5 Supplies and user maintenance 1 2 Gently pull the TD cartridge out while pressing the lock release button. Dispose of the old TD cartridge in accordance with local regulations. Lock release button 20 TD CARTRIDGE REPLACEMENT 3 Remove the TD cartridge from the bag. Hold the cartridge on both sides and shake it horizontally four or five times. Hold the tab of the protective cover and pull the tab to remove the cover. 4 or 5 times 4 Gently insert the TD cartridge until it locks in place. 5 Supplies and user maintenance 5 Close the front cover and then the side cover by pressing the round projections near the side cover open button. When closing the covers, be sure to close the front cover securely and then close the side cover. If the covers are closed in the wrong order, the covers may be damaged. 21 USER MAINTENANCE Proper care is essential in order to get clean, sharp copies. Be sure to take a few minutes to regularly clean the copier. q Do not use thinner, benzene or other volatile cleaning agents. Doing so may cause deformation, discolouration, deterioration or malfunction. Before cleaning, be sure to turn the power switch off and remove the power cord from the outlet. q Cabinet Wipe the cabinet with a soft, clean cloth. Original table and original cover Stains on the glass or cover will also be copied. [. . . ] outlet, and contact your HASBRO dealer. 6 Copier trouble? 10 24 _ _ DISPLAYING TOTAL NUMBER OF COPIES Use the following procedure to display the total number of copies. 1 2 Press the clear ( ) key to reset the display to zero. Press and hold down the clear ( ) key for approximately 5 seconds. The total number of copies will appear in two steps, each with three digits. Example: Total number of copies is 1, 234. 29 AUTOMATIC EXPOSURE ADJUSTMENT The automatic exposure level can be adjusted to suit your copying needs. 1 Press the exposure mode selector key to select the photo ( ) mode. 2 Press and hold down the exposure mode selector key for approximately 5 seconds. The photo ( ) indicator will go out and the AUTO indicator will begin to blink. [. . . ]