User manual HASBRO WHICH WITCH

[. . . ] Quest' apparecchio è conforme ai requisiti delle direttive 89/336/EEC e 73/23/EEC, come emendata dalla direttiva 93/68/EEC. AõôÞ ç óõóêåõÞ óõoñøþvåôáé å ôéò áðáéôÞóåéò ôùv ïäçãþv ôoõ Óõâoõëßoõ 89/336/EOK êáé 73/23/EOK üðùò ôñoðoðoéçèêáv áðü ôçv ïäçãßá ôoõ Óõâoõëßoõ 93/68/EOK. Este equipamento obedece às exigências das directivas 89/336/CEE e 73/23/CEE, na sua versão corrigida pela directiva 93/68/CEE. Este aparato satisface las exigencias de las Directivas 89/336/CEE y 73/23/CEE, modificadas por medio de la 93/68/CEE. [. . . ] The TV menu offers settings for recording and connections and for TV settings. Under "Recording" you will find the functions (when a recorder is logged in): Recording wizard · Via EPG · Via teletext (VPS) · Manual Note: You will find further information about timer recording on page 31. AVL timer list Here you will find a list of channels programmed for recording. You can change the recording data or delete programmed recordings completely and programme new recordings. Pre-/Post record time For recordings without VPS/PDC you set a pre and post time here so that the programme is fully recorded in case of slight differences in the time. Under "Connections" you will find the following functions: AV setup The connection wizard helps you connect and log in additional equipment such as video recorders, DVD players/recorders, camcorders/digital cameras, pay TV decoders, equipment with component signals and digital HDMI signals. Antenna DVB · Antenna DVB-T · Satellite DVB-S * You will find further details on page 9/10. * Units with Digital satellite tuner 19 Demo mode Open index with INFO. The Demo function allows you to see the most important menus implemented in this TV set. AVL timer list TIMER If timer recordings have been programmed you will see when and which station was recorded here. AVL timer list 30. 06. 19:00-19:15 ZDF Heute Thu 30. 06. /13:51 Press the red button to go to the menu for the "Recording wizard" (see page 31). Modes of operation AV-Link Transmission of the programme data from the TV set to the video/DVD recorder if a recorder with AV Link is logged in. Miscellaneous (connections) · Set AV standard for the connections manually (if it is not recognised automatically). Interchange the pictures with the yellow button. Select the station of the PIP picture The frame around the PIP must be green. Then select the station as normal. 2 ZDF Functions in the PIP menu In the PIP menu you set the PIP type (small picture or split screen) and the position of the small picture. Call the PIP menu (PIP must be active). TV menu -> Setup PIP Parental lock Timer functions Language Miscellaneous Channels Type Small PIP Split Screen PIP type: Split Screen You can have the PIP picture displayed on the right hand side of the screen. Switch to split screen: Select "Split Screen". 21 Modes of operation Position of the PIP picture TV menu -> Setup PIP Parental lock Timer functions Language Miscellaneous Channels Type Small PIP Split Screen Select "Small PIP" . Select the desired PIP position. TV menu -> Setup PIP Parental lock Timer functions Language Miscellaneous Channels Type Position Small PIP upper left bottom left bottom right upper right END INFO BACK END PIP type: Small PIP You can have the PIP picture displayed as a small picture. Switch to small picture: Select "Small PIP". TV menu -> Setup PIP Parental lock Timer functions Language Miscellaneous Channels Type Position Small PIP Split Screen bottom right INFO BACK The frame around the PIP picture must be green and no other displays should be visible on the screen. END INFO BACK 22 Modes of operation EPG ­ Programme guide EPG is the electronic programme guide for TV programmes. With this system, you can easily find the stations that interest you (sorted according to day, time, programme and topic). Depending on whether you are receiving analogue stations by cable/antenna or digital stations, you will have different programme guides. A wizard is activated the first time you use EPG (not with DVB) which guides you through the necessary settings. Then run the data acquisition (see next page). the MENU button, then select "Station selection", you can select the double-listed station and deactivate it with OK ( is deselected). You have direct access to the selection lines to pre-select the day, the time, the station and the topic. [. . . ] 2Vrms Centre 2 x Cinch Audio IN L/R 2 x Cinch Audio OUT L/R EXT 3 (Cinch) COMPONENT IN: Cb/Pb signal COMPONENT IN: Cr/Pr signal COMPONENT IN: Y signal Cinch Digital Audio IN (SPDIF) Digital audio Cinch Digital Audio OUT (SPDIF) Digital audio EXT 4 (Mini-DIN) Video IN Y/C (S-VHS/Hi 8) EXT 4 (yellow) Video IN CVBS (VHS/8 mm) Cinch (white/red) Audio IN L/R Jack 3. 5mm Headphones 32­2000 ohm EXT 5 Digital Video/Audio IN type A 19pin Digital video and audio PC IN D-sub 15 pin PC/STB video signal Mini-DIN Service * Units with Digital satellite tuner 795x638x307 917x707x307 795x576x108 917x645x108 16:9 80 cm 1366x768 800:1 170° 20, 5 85 <3 16:9 94 cm 1366x768 800:1 170° 24, 2 100 <3 General Operating temperature Relative humidity Atmospheric pressure Power supply Tuner VHF/UHF/ cable Hyperband 8 MHz Station slot memory TV standards Colour standard Sound standard Rated audio power Analogue Teletext Page Memory Digital Teletext (in UK only) 0º ­ 40º Celsius 20 . . . 2000 m) 220 V ­ 240V/50­60 Hz 41 MHz to 860 MHz 430 / to DVB 1680 B/G, I, L, L`, D/K, M, N PAL, SECAM, NTSC, PAL 60Hz Mono/Stereo/Bilingual Nicam B/G, I, L, Virtual Dolby 2 x 10 Watt/6 Ohm Top/FLOF Level 2. 5 3500 MHEG-5 The code number 3001 cancels out a secret code and with it the Parental lock. CH/05/11/1. 3 36 Troubleshooting Problem "Recording" is not displayed in the TV menu "Connections" for example cannot be called in the TV menu (grayed out) The control of the video recorder and the timer do not work or do not work properly. Possible cause No video or DVD recorder logged in A time recording is in progress a) The AV Link function is not activated or not possible in the video recorder b) Euro AV cable not connected a) The device is not logged in in the connection wizard or connected differently to shown in the connection diagram. [. . . ]