User manual HASBRO WCW NITRO HOLLYWOOD HOGAN090

[. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Use nothing but the included cables and AC cord to insure compliance with FCC regulation for Class B computing equipment. Operation is subject to the following conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undersized operation. [. . . ] - Do not place the monitor on top of unstable objects or in unsafe places. Do not allow the monitor to come into contact with strong shocks or vibrations. - Do not use in places where the monitor will be subject to direct sunlight, near heating equipment or anywhere else where there is likelihood of high temperature, as this may lead to generation of excessive heat and outbreak of fire 19) When the OSD Menu is not displayed: These buttons are used to adjust backlight brightness (p. 19) This button is used to select menu options when the OSD Menu is displayed. Ventilation Note: Never block the ventilation openings as this may lead to openings overheating inside the monitor and result in malfunction. INPUT 2 terminal and USB port Remove the cover to view the computer input terminal (INPUT 2) and USB port. Security lock anchor By connecting a security lock (purchased separately) to the security lock anchor, the monitor is fixed so that it cannot be transported. The theft prevention hole works in conjunction with Kensington Micro Saver Security Systems. Connecting the monitor and turning the monitor on and off Run cord through hole. Connecting the monitor and turning the monitor on and off When connecting, ensure that both the monitor and computer are switched off. Firmly insert the analog RGB output terminal (mini D-sub 15 pin with 3 rows) then tighten the screws each side. Note: - When setting up the monitor or a connected computer for the first time, connecting an additional computer or after having changed an aspect of the current system, perform an automatic screen adjustment before use Automatic adjustment screen display To perform an automatic adjustment, first display an image that makes the entire screen very bright. If you are using Windows, you can also use the Adjustment Pattern on the accompanying Monitor Settings Adjustment Disk for Windows. displaying the Adjustment Pattern (for Windows) This explanation is for Windows 95/98/2000 , and assumes that the floppy disk drive is [A drive]. Note: - If the floppy disk drive of your computer is not "A drive", please read the below substituting the floppy disk drive you are using in place of "A drive" or "A". Press the MENU button 4 times to make the On Screen Display (OSD) Menu disappear. Notes: - In most cases the monitor is ready to be used after automatic adjustment. (When the screen displays an entirely dark image, the automatic screen adjustment may be disabled. When making an automatic adjustment, be sure to either use the Adjustment Pattern or try displaying an image that makes the entire screen very bright. Carry out the commands without the On Screen Display (OSD) Menu displayed. If the OSD Menu is displayed, press the MENU button (several times may be required) and begin when the OSD Menu has disappeared. - If your computer's display mode is set to 65K colors, you may see the different color levels in each color pattern or the gray scale may look colored. [. . . ] Follow your computer's instruction manual to set the timing to be compatible with the monitor. - If the monitor is not receiving any signal (synch signal), [NO SIGNAL] will appear. Function Red video signal input Green video signal input Blue video signal input GND GND For red video signal GND For green video signal GND For blue video signal GND N. To activate the monitor's Power Management function, both the video card and the computer must conform to the VESA DPMS standard. [. . . ]