User manual HASBRO WATERWORLD 1995

[. . . ] Z Audio-visual material may consist of copyrighted works which must not be recorded without the authority of the owner of the copyright. Notes: z Parts and equipment mentioned in this operation manual other than those detailed above are not included. Z Do not wear your headphones when you are crossing streets or near traffic. Z Do not use your headphones whilst driving a motor vehicle, it may create a traffic hazard and may be illegal. [. . . ] (Pause function does not work for approximately 10 seconds after a recording starts. ) When the microphone picks up sound again, recording starts automatically. Notes: z Whilst making a mic recording, do not connect anything to the OPTICAL/LINE IN socket on the portable MD. - When a plug-in-power type microphone is plugged in , the portable MD will provide power for the microphone's operation. - If a different type of microphone is plugged in, it may not operate properly or it may cause the unit to malfunction. Z If the unit starts recording too often from low unwanted noises, set the microphone input to "MIC SYNC L". MIC SYNC H : Recording starts when the unit detects ---24 dB or more (The unit can start recording from quiet sounds). When a sound, such as person speaking, is picked up by the microphone, recording will begin automatically. When recording from the microphone, track numbers will be created automatically at regular intervals (default setting: approximately every 5 minutes). During a mic synchro recording, the unit pauses when a silence lasts for 3 seconds or more, and creates a track number. If a silence lasts for 3 seconds or more, a timed auto mark will be created 5 minutes after the previous mark is created. The first 3 characters in the group of the selected characters will be displayed for about 1 second. "TOC" will not disappear until the recorded contents have been updated. Press the VOL+ or VOL--- button to move the cursor to the character you want to erase, and then press the BASS button. , , To enter a space Note: One disc name and up to 255 track names can be created per disc (a maximum of 100 characters for the disc and each track name and a total of 1, 700 characters can be entered). When there are 2 MiniDiscs on which the same tracks are recorded, you can transfer the character information (disc and track names) of the Master MiniDisc to another MiniDisc (for stamping). a recordable MiniDisc that contains tracks and character information. Press the VOL+ or VOL--- button to move the cursor to the right of the character, where you want to add a new character. "TOC" will not disappear until the recorded contents have been updated. A MiniDisc that contains the same tracks in the same order as the master MiniDisc. (Make sure that the total number of tracks of the master MiniDisc and the one for stamping are the same. The unit will finish recording the character information and enter the stop mode. [. . . ] When the unit has condensation inside, the disc signals cannot be read, and the unit may not function properly. Z When the unit is placed in a room where there is excessive steam or moisture. Caution: z Do not use chemicals for cleaning (petrol, paint thinner, etc. As a part of our policy of continuous improvement, HASBRO reserves the right to make design and specification changes for product improvement without prior notice. [. . . ]