User manual HASBRO WALK ALONG SESAME STREET

[. . . ] Le servirá también como guía operativa de este producto HASBRO. HASBRO HASBRO WALK ALONG SESAME STREET OPERATION MANUAL MODE D'EMPLOI MANUAL DE MANEJO 30 E-30. S-30. HASBRO CORPORATION 06/4/7 GX-CD5100V_FRONT. fm TINSEA095AWZZ WALK ALONG SESAME STREET ENGLISH Special notes Supply of this product does not convey a license nor imply any right to distribute content created with this product in revenue-generating broadcast systems (terrestrial, satellite, cable and/or other distribution channels), revenue-generating streaming applications (via Internet, intranets and/or other networks), other revenue-generating content distribution systems (pay-audio or audio-on-demand applications and the like) or on revenue-generating physical media (compact discs, digital versatile discs, semiconductor chips, hard drives, memory cards and the like). MPEG Layer-3 audio coding technology licensed from Fraunhofer IIS and Thomson. [. . . ] To repeat a desired track: Perform steps 1 - 6 in the "Programmed play" section on page 16 and then press the / ( / ) button twice. " " will disappear. Direct track search By using the direct search buttons, the desired tracks on the current disc can be played. Use the direct search buttons on the remote control to select the desired track whilst playing the selected disc. Selected track number The direct search buttons allow you to select up to number 9. 2 Press the "3" button. Random play The tracks on the disc can be played in random order automatically. To random play all tracks : Press the RANDOM button on the remote control. B. For example, to choose 30 1 Press the "+10" button three times. 2 Press the "0" button. To cancel random play: Press the / ( / ) button. "NORMAL" will appear for 2 seconds. E-15 04/1/28 GX-CD5100V_EN1. fm WALK ALONG SESAME STREET Notes: If you press the button during random play, you can move to the track selected next by the random operation. On the other hand, the button does not allow you to move to the previous track. (You cannot select the order of the tracks. ) Caution: After performing repeat or random play, be sure to press the button. ) button for less than 0. 5 seconds to se- WALK ALONG SESAME STREET ENGLISH To scan the preset stations The stations saved in memory can be scanned automatically. (Preset memory scan) 1 Press the PRESET ( or ) button for more than 0. 5 seconds. The preset number will flash and the programmed stations will be tuned in sequentially, for 5 seconds each. 2 Press the PRESET ( or ) button again when the desired station is located. To erase entire preset memory 1 2 Press the ON/STAND-BY button to enter the stand-by mode. Whilst pressing down the REC PAUSE button and the CONTINUOUS PLAYBACK button, press the TUNER (BAND) button until "TUNER CL" appears. To change the FM/MW tuning interval: 1 Press the ON/STAND-BY button to turn the power on. 2 Press and hold down the TUNER (BAND) button, for 3 seconds. or 3 The display will appear for 2 seconds and the new setting is activated. Caution: When the unit is left for a few hours after the span has been switched and the AC power lead disconnected, the FM span will be automatically returned to 50 kHz (MW span to 9 kHz). When the span is switched, all the memorised stations will be cancelled. E-18 04/1/28 CX-GD5100V_EN2. fm Radio The International Telecommunication Union (ITU) has established that member countries should maintain either a 100 kHz or 50 kHz interval between broadcasting frequencies of FM stations and 10 kHz or 9 kHz for MW stations. The illustration shows the 50/9 kHz zones (regions 1 and 3), and the 100/10 kHz zone (region 2). However, it will be adjusted to a 50 kHz FM (9 kHz MW) interval when shipped from the factory. Before using the unit, be sure to set it to the FM/MW tuning interval (span) used in your area. WALK ALONG SESAME STREET Listening to a cassette tape (TAPE 1 or TAPE 2) Before playback: For playback, use normal or low-noise tapes for the best sound. (Metal or CrO tapes are not recommended. ) Do not use C-120 tapes or poor-quality tapes, as they may cause malfunctions. [. . . ] or button. To the line output sockets CD/LINE INPUT RIGHT LEFT 4 5 Play the VCR, etc. Advanced Features Red Headphones White Red White Before plugging in or unplugging the headphones, reduce the volume. Be sure your headphones have a 3. 5 mm (1/8") diameter plug and impedance between 16 and 50 ohms. Adjust the volume using the VOLUME control. RCA lead (not supplied) Listening to playback sounds of VCR, DVD, etc. 1 2 3 4 Connect a VCR, DVD, etc. You can enjoy sounds from the supplied speakers. E-27 04/1/28 CX-GD5100V_EN2. fm Troubleshooting chart Many potential problems can be resolved by the owner without calling a service technician. [. . . ]