User manual HASBRO UPWORDS 1997

[. . . ] Indd 1 2011-12-28 4:27:10 safety instructions Throughout this manual, you’ll see Warning and Caution notes. These warnings, cautions, and the important safety instructions that follow do not cover all possible conditions and situations that may occur. It’s your responsibility to use common sense, caution, and care when installing, maintaining, and operating the dishwasher. IMPORTANT SAFETY INSTRUCTIONS What the icons and signs in this installation guide mean: WARNING Hazards or unsafe practices that may result in severe personal injury or death. [. . . ] temperature should not exceed 149 ˚F (65 ˚C) to prevent damage to dishes. Ensure that the water supply valve is turned off before connecting the hot water supply line to the dishwasher. Seal the hot water supply line connections using teflon tape or sealing compound to stop any water leakage. The hot water supply line must pass through the channel on the bottom of the dishwasher as shown in Figure 2. The drain hose connected to the dishwasher must be run through the hole in the side wall so it can be connected to the drain outlet of the sink. When you install the dishwasher, ensure there is nothing on the drain hose and be careful not to tear it during the installation process. Indd Sec3:9 2011-12-28 4:27:24 installing the dishwasher STEP 4 CHECK THE ELECTRICAL REQUIREMENTS AND CAUTIONS The electrical requirements for the dishwasher are as follows: • In the United States, install in accordance with the National Electric Code/State and Municipal codes and/or local codes. - Use flexible, armored or non-metallic sheathed, copper wire with a grounding wire that meets the wiring requirements for your local codes and ordinances. - Use the strain relief method provided with the wiring junction box or install a U. € For power cord connections - The power supply cord must plug into a mating three prong, grounded outlet, located in the cabinet next to the dishwasher opening. The dishwasher must be connected to an electrical supply that provides the voltage and amperage marked on the rating plate of the unit: 15 amps, 120 volts, 60Hz AC. Adjust the three leveling legs at the bottom of the dishwasher after measuring the height of the cabinet opening from under the countertop to the floor. Place the dishwasher so that the hot water supply line is in the left channel and the power cable is in the right channel of the base of the dishwasher. Use standard duct tape or cable ties to secure the water line and electrical cable to their adjacent channels in the base. This can prevent the the water line and electrical cable from being squeezed when you push the the dishwasher into place. Make sure the hot water supply line is not twisted, and then connect the hot water supply line to the elbow joint. If possible, gently pull any excess lengths of water supply line, drain hose, or power cable back as you move the dishwasher. CAUTION Do not place the dishwasher on the water supply line, drain hose, or power cable. <Figure 7> <Figure 6> Drain hose Power cable Hot Water Supply Line Hot Water Supply Line Elbow( ³/8” (9. Doing so may damage the water inlet valve and cause a water leak 14_ installing the dishwasher installation_DD68-00046A-05_EN. indd Sec3:14 2011-12-28 4:27:24 STEP 8 LEVELING THE DISHWASHER 1. Open the door and place the level against the top of the tub on the inside and check if the the dishwasher is level. [. . . ] There are several ways to insert the drain hose into the drain hose connector of the sink, as shown in the following figures. You must connect the drain hose in accordance with the water pipe installation regulations in your region. With disposal With disposal Disposal with an air gap Air gap Without an air gap Drain hose Hose clamp Hose clamp 18_ installing the dishwasher installation_DD68-00046A-05_EN. If needed, cut the drain hose so its end fits onto the sink connector (1/2 in. [. . . ]