User manual HASBRO UNCLE WIGGILY 1967

[. . . ]  If the appliance is levelled correctly, it will be more stable and much less likely to cause vibrations and noise while it is operating, particularly during the spin cycle.  If it is placed on carpet or a rug, adjust the feet in such a way as to allow a sufficient ventilation space underneath the washing machine. Connecting the electricity and water supplies Connecting the water inlet hose  Before connecting the inlet hose to the water supply, run the water until it is perfectly clear. Connect the inlet hose to the machine by screwing it onto the cold water inlet of the appliance, which is situated on the top righthand side of the rear part of the appliance (see figure). [. . . ] Turn the WASH CYCLE SELECTOR KNOB right or left, until you have selected the desired wash cycle. A temperature and spin speed is set for each wash cycle; these may be adjusted. Use the relevant buttons on the control panel: Modify the temperature and/or spin speed. The machine automatically displays the maximum temperature and spin speed values set for the selected cycle, or the most recently-used settings if they are compatible with the selected cycle. The temperature can be decreased by pressing the button, until the cold wash ( ) setting is reached. The spin speed may be progressively reduced by button, until it is completely excluded pressing the ). If these buttons are pressed again, the ( maximum values are restored.  Exception: if the “Cotton” programme is selected, the temperature can be increased up to a value of 90°C. Is shown on the display and the After selecting a DELAY TIMER time, the fixed symbol and the cycle duration will appear on the display. To remove the DELAY TIMER option, 8 press the button until the display shows the text OFF; symbol will disappear. The Once the START/PAUSE button has been pressed, the time delay may only be decreased.  Concentrated Detergent To modify the degree of detergent density (refer to the chapter "Auto Dose System").  Fabric softener dosage To dose the amount of fabric softener (refer to the chapter "Auto Dose System"). Extra rinse By selecting this option, the efficiency of the rinse is increased and optimal residual detergent removal is guaranteed. We recommend this option is used with a full load of washing, or when a large amount of detergent is required. 9 Detergents and laundry EN Detergent The type and quantity of detergent required depend on the type of fabric you are washing (cotton, wool, silk, etc. ), as well as its colour, the washing temperature, the level of soiling and the hardness of the water in the area. Whenever the detergent and fabric softener “Auto Dose System” is activated, this washing machine helps to prevent wastage and to protect the environment, besides guaranteeing optimal washing performance. We recommend the following: • Use powder detergent for carrying out a pre-wash and pour in the "traditional" mode. • Use liquid detergents for delicate cotton garments and for all low-temperature wash cycles. • When activating the "Auto Dose System" mode, use liquid detergent and fabric softeners only. • Use gentle liquid detergents for wool and silk garments and pour in the "traditional" mode. [. . . ] Special anti-draining valves are available in shops and help to prevent this inconvenience. • The wash cycle does not include draining: Some wash cycles require the drain phase to be started manually (see “Wash cycles and options”). • • • • The The The The drum was not unlocked correctly during installation (see “Installation”). • The detergent dispenser is blocked (to clean it, see “Care and maintenance”). [. . . ]