User manual HASBRO MY LITTLE PONY CRYSTAL RAINBOW CASTLE 62514 2006

[. . . ] 4. When the iron has reached the correct temperature, the pilot light (J) goes out. 5. Hold the iron horizontally and repeatedly press the shot of steam button (A). It may smoke and smell – this is normal and will cease after a short while. 6. If necessary, carefully clean the soleplate down with a dry, folded cloth Environmental Care This iron has been designed according to ecological criteria, related to the sustainable development, analyzing its whole lifecycle - from material selection to its later reusing or recycling - evaluating the improvement possibilities, from a technical, economical and environmental point of view. [. . . ] If it is absolutely necessary to use an extension cable, make sure that it is suitable for 16A and has a socket with an earth connection. • The iron should not be used if it has been dropped, if there are visible signs of damage or if it is leaking water. It must be checked by an authorized Technical Service Centre before it can be used again. • Do not allow the power cable to come into contact with the soleplate when it is hot. • In order to avoid that, under unfavourable mains conditions, phenomena like transient voltage drops or lighting fluctuations can happen, it is recommended that the iron is connected to a power supply system with a maximum impedance of 0. 27Ω . If necessary, the user can ask the public power supply company for the system impedance at the interface point. • This appliance is not intended to be used by persons (including children) with reduced physical, sensory or mental capacities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety. • Children should be supervised to ensure that they do not play with the appliance. • Remove the plug from the socket before filling the appliance with water or before pouring out the remaining water after use. • When placed on its stand, make sure that the surface on which the stand is placed is stable. • The iron must not be left unattended while it is connected to the supply mains. Any damage caused by the use of the aforementioned products, will make the guarantee void. Do not use condensation water from tumble dryers, air conditioners or similar appliances. To prolong the optimum steam function, mix tap water with distilled water 1:1. If the tap water in your district is very hard, mix tap water with distilled water 1:2. You can inquire about the water hardness with your local water supplier To prevent spillage of water out of the appliance in vertical position, never fill beyond the «max» water level mark! Set the steam regulator (C) to the position and ma x 2. If you are unsure what type of material the garment is made from, start ironing on the lowest temperature setting and increase accordingly. If the garment is made from mixed fabrics, set the temperature for the most delicate material. 3. For silk, woollen or synthetic materials iron the reverse side of the fabric to prevent shiny patches. 4. Sort your garments based on their care labels, always starting with clothes that have to be ironed at the lowest temperature. 5. The pilot lamp (J) will stay lit while the iron is heating up and go out once the selected temperature has been reached. Once the iron is ready, you can continue to iron even if the pilot lamp comes on again. 6. If your iron has auto shut-off and the pilot light (M) is flashing, the auto shut-off has activated. [. . . ] 4. Hold the iron with the point facing up and shake it gently until all the water has come out. 6. Coil the power cable (L) loosely around the heel of the iron, before storing. Self Cleaning The self clean function helps remove lime scale that has built up around the steam valve. The “secure” auto shut-off function switches off the iron automatically when it is not being used, thus helping to prevent accidents and saving energy. [. . . ]