User manual HASBRO CONTACT

[. . . ] Which appears in these Steps indicates that you should keep pressing the button repeatedly until you see the display indicated. The setting is engaged and the second line of the display stops blinking. Which appears in these Steps indicates that you should keep pressing the button repeatedly until you see the display indicated. XXXX represents your media size choice (for envelopes, select The setting is engaged and the second line of the display stops blinking. [. . . ] XXXX represents your media size choice (for envelopes, select The setting is engaged and the second line of the display stops blinking. The setting is engaged and the second line of the display stops blinking. 5" x 14" [216 x 356 mm] (Non-standard sizes must be defined in driver before printing: see your on-line User's Guide [on the Publications CD]. Feed stack = about 3/8-inch (1 cm) high Single-sided printing: load face up, top edge into the printer. ⷠDouble-sided printing: load face down with top edge away from the printer. Media Weight, US Bond (see page 5) [sometimes given as substance] Media Weight, Metric: Look for this to confirm US Bond vs Index. The ink on pre-printed letterhead stationery must be able to withstand 446°F (230°C) for 0. If you experience curling when printing a file in duplex mode, switch to 28-lb. Transparencies must be able to withstand 446°F (230°C) for 0. Make the following settings in the printer driver as you print the job: · Labels must be able to withstand 446°F (230°C) for 0. If the sheet is well advanced into the fuser, see step 4 under "Jam 382. If the sheet is trapped in the fuser, lift the top cover, reach in and push the fuser pressure release lever (1) towards the front and down, and pull out the sheet. 4 Make sure the lever is pulled all the way forward before attempting to remove the toner cartridge!Appears on the second line of the display to indicate that the lever for the toner cartridge color indicated is not pushed all the way back. Push the lock lever toward the back of the printer as far as it will go. Appears on the second line of the display to indicate that color XXX toner cartridge is getting low. Note:If you have changed the LOW TONER item in the SYSTEM CONFIG MENU to STOP, the ATTENTION light will blink and you must either replace the toner cartridge immediately or press the ON LINE button to continue printing. Install additional memory in the printer (see your on-line User's Guide for more information). The printer has received a job for printing from the Multi-Purpose Tray and no media is loaded in the tray. The stack of paper in the top (face down) output tray is blocking the printed sheets trying to exit the printer. [. . . ] The printer has received a job for printing from the Multi-Purpose Tray and no media is loaded in the tray. The stack of paper in the top (face down) output tray is blocking the printed sheets trying to exit the printer. Load the requested media (XXX) in the Multi-Purpose Tray, then press ON LINE. Appears on the second line of the display to indicate that the media in tray t is almost out. [. . . ]