User manual HASBRO CANDY LAND 2004

[. . . ] Playset comes with skiff, radar dish, launchers, 2 projectiles, prisoner containment unit, spaceship, space rover vehicle, Buzz Lightyear figure and Zurg figure. To Assemble · Snap center section of playset onto base. · Snap prison cell onto center section as shown. · Snap prisoner containment unit onto prison cell. Note: To conserve batteries, move switch to "OFF" position when youre not using the playset. ON/OFF switch · Snap-on gun/scope and radar dish can attach to several places on the playset. · Make sure ON/OFF switch is in "ON" position for electronic lights and speech. To Play · Push slide up and down to move elevator! · Push button on gun to fire projectile! · Prison cell swivels out! To Play (continued) Button · 2 docking stations for skiff (indicated by red dots)! · Dock skiff in front of computer screen, then press gently on skiff for electronic speech and lights!(Electronic features can also be activated by pressing button under the computer screen. ) · Squeeze containment unit shut, · Zurg figure fits inside containment unit when placed then detach and snap onto skiff! [. . . ] If figure is placed in any other position, unit will not close properly. · Buzz Lightyear figure has hole in back to fit backpacks (sold separately). To replace computer­screen light bulb Use a Phillips/cross head screwdriver to loosen screw in computer screen base (screw remains attached to base). Replace door and tighten screw. Spacer To Replace Batteries Use a Phillips screwdriver (not included) to loosen screw in battery compartment door (screw remains attached to door). Replace door and tighten screw. CAUTION: TO AVOID BATTERY LEAKAGE 1. Be sure to insert the batteries correctly and always follow the toy and battery manufacturers' instructions; 2. Do not mix old and new batteries or alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries; 3. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. [. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. [. . . ]