User manual HASBRO BABY ALIVE CHANGING TIME BABY

[. . . ] Water container – empty the water container after each drying cycle. Step 1 Pull the water container towards you and remove it completely from the dryer. Step 2 Empty all the water in the water container. Step 2 Pull out the filter (using two fingers). Step 3 Replace the water container making sure that it is securely fixed. Step 3 Clean off any fluff build-up on the internal surface of the filter. Failure to empty the water container may cause the following: - The dryer stops heating (thus the load may still be damp at the end of the drying cycle). - The “Empty water container” LED activates to show that the water container is full. Filling of the Water Container Step 4 Replace the filter – never operate the dryer without the filter in place. When the dryer is first used water will not immediately enter the water container as the pump needs to be primed. This is done automatically and will take a few minutes, during this period the efficiency of the drying process is not affected. 2 Condenser unit - remove any fluff build-up from the condenser on a monthly basis. Step 1 Open the condenser cover - grip the handle and pull towards you. EN Step 2 Remove the condenser by turning the 3 catches, then pull the condenser towards you. [. . . ] One of the “Delay timer” indicator light flashes to signal the delay time entered. • It is necessary to press the START/PAUSE button to resume the programme. The progress indicator lights signal the running phase and the START/PAUSE indicator light stops flashing and turns green. Pressing the START/PAUSE button reactivates a new programme from the beginning. • By turning the Programme selection knob, a new programme is selected and the START/PAUSE indicator light flashes green. This procedure can be used to select the Cold drying programme to cool garments if they are judged to be dry enough. Note: In the event of a power cut, turn the power switch off and remove the plug; when the electricity supply returns, press the START/PAUSE button to resume the programme. 10 Laundry Sorting laundry • Check the symbols on the care labels of the various garments to verify whether the garments can be safely tumble dried. • Close zips and hooks and fasten belts and strings without tightening them. • Wring out garments to remove the maximum amount of water possible. Care labels Always check the care labels, especially when placing garments in the tumble dryer for the first time. Below are the most commonly used symbols: May be tumble dried. Do not load the dryer when garments are dripping wet. Maximum load sizes Do not overload the drum. • Always comply with electrical regulations and requirements (see Installation). • Always purchase original accessories and spare parts (see Assistance). WARNING: Never stop the dryer before the end of the drying cycle unless all items have been quickly removed and hung in order to dispel heat. EN General safety • The final part of a tumble dryer cycle occurs without heat (cooling cycle) to ensure that the laundry is not damaged due to excessive temperatures. • This tumble dryer must not be used by persons (including children) with physical, sensory or mental impairments or with little experience and knowledge of the appliance, unless they are supervised or have been adequately instructed on its use by the person responsible for their safety. • This tumble dryer is designed for domestic and nonprofessional use. • Do not touch the appliance while barefoot or with wet hands or feet. • Do not allow children near the appliance while it is in function. • Children must be supervised to ensure that they do not play with the appliance. • The appliance must be correctly installed and receive adequate ventilation. The air intake on the front part of the dryer and the air vents on the rear must never be obstructed (see Installation). • Never use the dryer on carpeting with high pile as this may prevent air from entering the dryer from the base. [. . . ] Press the On/Off button and the lights will come on again. 15 Assistance Before contacting the Technical Assistance Centre: EN Spare parts This dryer is a complex machine. Attempting to repair it personally or with the aid of an unqualified personnel may put the safety of people at risk, damage the machine or invalidate the spare parts guarantee. Always contact a qualified technician when experiencing problems with this machine. The spare parts were designed exclusively for this machine and should not be used for any other purpose. • Follow the troubleshooting guide to check whether problems can be solved personally (see Troubleshooting). [. . . ]