User manual HASBRO AIR-POWERED ACTION STADIUM

[. . . ] Make sure they SNAP into place. 3b: Slide stadium halves together, sliding connecting snaps and connecting plugs all the way into slots on other stadium half. 2a: Using screwdriver, turn locks to unlocked position (arrow on lock points toward stadium center). 3c: Turn locks clockwise to locked position (arrow on lock points away from stadium center). flap switch 2b: Slide connecting plugs all the way into side slots on one stadium half as shown. 4: Attach leg with flap to battery compartment end 2c: Turn locks clockwise to locked position (arrow on lock points away from stadium center). of stadium (slide tabs on leg into slots on stadium). [. . . ] Press the Game Select button to select the game of your choice (see Game Select button description above). Once you have stopped on the game of your choice, the announcer will pause and then announce game start. One player starts the game by placing a puck in the stadium and aiming for the goal. When a goal is scored, the goal light will illuminate, and one point will be announced for the player who scored the goal. "GOAL!" The toy will keep track of all points scored during the game. During the game, when a player scores the final goal (5, 7 or 10 points depending on which game was selected) the buzzer will sound and the winner and final score will be announced. To play again, press the Game Select button to start or select a new game. If you do not press the Game Select button within 3 minutes, the toy will shut off. PINBALL 1. Manually lift the Player Two side of the stadium, then turn the lever clockwise until it stops, and lower the stadium. Press the Game Select button to select the game of your choice (see Game Select button description on previous page). Once you have stopped on the game of your choice, the announcer will pause and then announce game start. The air will turn on, and you are ready to play. Optional: For more advanced play, you can use the hockey paddles as pinball bumpers. Turn the paddles upside down, and press the center section (inside the felt ring) to expose posts on the other side. Note: If you don't use the paddles, convert them to bumpers and store them at the Player Two corners as shown. PINBALL "PRACTICE" This mode allows you to work on your pinball skills without a time limit or total score. [. . . ] This equipment generates, uses and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ]