User manual HARVIA HYGROMETER-THERMOMETER

[. . . ] No such objects or devices should be placed inside the heater stone space or near the heater that could change the amount or direction of the air flowing through the heater. Rearrange the stones at least once a year or even more often if the sauna is in frequent use. At the same time, remove any pieces of stones from the bottom of the heater and replace any disintegrated stones with new ones. By doing this, the heating capability of the heater stays optimal and the risk of overheating is avoided. [. . . ] Therefore, it is necessary to throw water on the heated stones to reach a suitable level of humidity in the sauna. The effect of heat and steam on people varies ­ by experimenting, you can find the levels of temperature and humidity that suit you best. If an excessive amount of water is poured on the stones, only part of it will evaporate and the rest may splash as boiling hot water on the bathers. Never throw water on the stones when there are people near the heater, because hot steam may burn their skin. The water to be thrown on the heated stones should meet the requirements of clean household water (table 1). Recommendation Empfehlung <12 mg/l <0, 2 mg/l Mn: <0, 05 mg/l Ca: <100 mg/l Forbidden to use Darf nicht verwendet werden Forbidden to use Darf nicht verwendet werden Water property Effect Wassereigenschaft Wirkung Humus concentration Colour, taste, precipitates Humusgehalt Farbe, Geschmack, Ablagerungen Iron concentration Colour, odour, taste, precipitates Eisengehalt Farbe, Geruch, Geschmack, Ablagerungen Hardness: most important substances are Precipitates manganese (Mn) and lime, i. According to established sauna conventions, you must not disturb other bathers by speaking in a loud voice. Do not force other bathers from the sauna by throwing excessive amounts of water on the stones. If you are in good health, you can have a swim if a swimming place or pool is available. Have a drink of fresh water or a soft drink to bring your fluid balance back to normal. Staying in the hot sauna for long periods of time makes the body temperature rise, which may be dangerous. If mechanical exhaust ventilation is used, place the supply air vent above the heater. If gravity exhaust ventilation is used, place the supply air vent below or next to the heater. KV-E: Do not place the supply air vent so that the air flow cools the temperature sensor (see the temperature sensor installation instructions in the control unit installation instructions)!Place the exhaust air vent near the floor, as far away from the heater as possible. The diameter of the exhaust air pipe should be twice the diameter of the supply air pipe. If the exhaust air vent is in the washroom, the gap underneath the sauna door must be at least 100 mm. When the walls and ceiling are covered with panels and insulation behind the panels is adequate, the heater output is defined according to the volume of the sauna. Add 1, 2 m³ to the volume of the sauna for each non-insulated wall square meter. For example, a 10 m³ sauna room with a glass door equals the output requirement of about a 12 m³ sauna room. if the sauna room has log walls , multiply the sauna's volume by 1 , 5. Bench towels should be used during bathing to prevent sweat from getting onto the benches. [. . . ] If the connecting and installation cables are higher than 1000 mm from the floor in the sauna or inside the sauna room walls, they must be able to endure a minimum temperature of 170 °C when loaded (for example, SSJ). Electrical equipment installed higher than 1000 mm from the sauna floor must be approved for use in a temperature of 125 °C (marking T125). In addition to supply connectors, the control centre is equipped with additional connectors which make the following connections possible (fig. The control cable for electrical heating is brought directly into the junction box of the heater, and from there to the terminal block of the heater along a rubber cable with the same thickness as that of the connection cable. [. . . ]