User manual HARVIA CLASSIC 280 TOP

[. . . ] The dealer or our factory representative can assist you in choosing the stove if needed. Upper connection opening Rear connection opening Soot opening Stove door Ash box Cover Handle The purpose of the stove's cover is to control air flow through the stove. While the cover is closed, the stones heat up but the sauna remains reasonably warm. Only when the cover is opened, the stove starts to heat the sauna room air at full power. [. . . ] If necessary, place more firewood into the fire chamber when the ember is dying down. It takes only a couple of pieces of wood to maintain the bathing temperature. excessive heating (several full loads in a row , for example) will make the stove and the chimney overheat. Overheating shortens the stove's life span and may cause risk of fire. The water that is thrown on the stones should be clean household water. Make sure the water is of high enough quality, because water containing salt, lime, iron or humus may prematurely corrode the stove. If you throw water on the hot steel surfaces, they may blister due to the large temperature variation. The ash box should always be emptied before heating the stove so that the combustion air that is lead through the box would cool off the fire grate and lengthen its life span. As the removed ash may include hot embers, do not keep the ash container close to combustible material. Soot and ashes gathered in the smoke canals of the stove should be removed occasionally through the soot openings ( 1. Therefore, they should be rearranged at least once a year or even more often if the sauna is in frequent use. At the same time, any pieces of stones should be removed from the stone space, and disintegrated stones should be replaced with new ones. There is low pressure caused by an extractor fan or another device in the room. You can speed up the heating process by adjusting the combustion air channels or by removing them ( 1. Remove the small pieces of stone and stones that are less than 10 cm in diameter from the stone space. The hot stove may emphasize odours mixed in the air that are not, however, caused by the sauna or the stove. Light-coloured floor materials will become dirty from the ash, particles of stone and metal flakes that fall from the stove. It is perfectly normal for the wooden surfaces of the sauna room to blacken in time. Agents have a poor heat resistance level) fine particles disintegrating from the sauna · Stones which rise with the air flow · Smoke that enters the sauna, for example, when adding firewood. When installation instructions given by the manufacturer are followed, the stove will not heat the inflammable material in sauna room to a dangerous level. The fresh air inlet must be placed close to the floor near the stove and B. Its outlet should be as far as possible from the stove and near the ceiling. [. . . ] The adjustable feet could scratch the floor surface if the stove is moved on the floor. Connecting the Stove to a Masonry Flue Make an opening in the fireproof wall for the flue connection. Turn the cover hatch back up and lock it in its position with a screw. Connect the steel chimney's smoke pipe to the upper connection opening of the stove. [. . . ]