User manual HANNA INSTRUMENTS HI 147-01

[. . . ] Instruction Manual HI147-00 · HI147-01 Checkfridge Thermometers with Cal-Check® Dear Customer, Thank you for choosing a Hanna product. This manual will provide you with the necessary information for correct operation. [. . . ] Any defective item must be returned in its original packing. Hanna Instruments reserves the right to modify the design, construction and appearance of its products without advance notice. IST147R3 07/05 www. hannainst. com 1. TEST/READ switch SPECIFICATIONS HI 147-00 Range -50. 0 to 150. 0°C Resolution 0. 1°C Accuracy (@25ºC/77ºF) ±0. 3°C (-20 to 90°C) ±0. 5°C (outside) Typical EMC Deviation ±0. 5°C HI 147-01 Range -58. 0 to 302°F Resolution 0. 1°F (-58. 0 to 199. 9°F), 1°F (200 to 302°F) Accuracy (@25ºC/77ºF) ±0. 6°F (-4 to 194°F) ±1°F (outside) Typical EMC Deviation ±1°F Common specifications Probe stainless steel probe with 1m cable Battery Type/Life 1 x 1. 5V AAA approx. 3 years of continuous use Dimensions 93 x 39 x 31mm (3. 7x1. 5x1. 2") Weight 60 g (2. 1 oz. ) OPERATIONAL GUIDE TAKING MEASUREMENTS · Turn the meter ON and set the TEST/READ switch in the READ position. If the meter is calibrated, in a few seconds the display will stabilize and show "0. 0" for HI 147-00, or "32. 0" for HI 147-01. To return to measurement mode, move back the TEST/READ switch to READ. Contact your dealer or the nearest Hanna Service Center for recalibration, if necessary. Notes: · Do NOT wrench the probe or put heavy objects on the cable. If the cable is damaged, the meter needs to be replaced. · Variations in readings or fading display can indicate a low battery level. CE DECLARATION OF CONFORMITY Recommendations for Users Before using these products, make sure that they are entirely suitable for the environment in which they are used. Operation of these instruments in residential areas could cause unacceptable interferences to radio and TV equipment. Any variation introduced by the user to the supplied equipment may degrade the instrument's EMC performance. To avoid electrical shock, do not use these instruments when voltages at the measurement surface exceed 24 Vac or 60 Vdc. To avoid damages or burns, do not perform any measurement in microwave ovens. BATTERY REPLACEMENT When the display fades, remove the two screws on the back. [. . . ] Reproduction in whole or in part is prohibited without the written consent of the copyright owner. Replace the cover and tighten the two screws. Battery should be replaced only in a safe area and using the battery type specified in this instruction sheet. [. . . ]