User manual HANNA INSTRUMENTS HI 98351

[. . . ] Wate rpro of DiST WP Conductivity/TDS Meters OPERATION: · Remove the protective cap. · Turn the DiST WP on with the ON/OFF switch located on the top. [. . . ] DiST WP compensates for the temperature automatically and variations on the display can be due to the temperature sensor adjusting to the new environment. CALIBRATION: The calibration procedure is simple and fast. · Immerse the tester into the appropriate optional Calibration Solution (see Specifications). · Allow the reading to stabilize and using a small screwdriver turn the Calibration Trimmer to match the solution value (normally to the value at 25°C). calibrating a DiST WP 1 using HI 7032 as calibration solution, turn the trimmer to read "1382". RECOMMENDATIONS FOR USERS: Before using these products, make sure that they are entirely suitable for the environment in which they are used. Operation of these instruments in residential areas could cause interference to radio and TV equipment. The pins at the end of the sensor are sensitive to electrostatic discharges. During operation of instruments, ESD wrist straps should be worn to avoid possible damage to the sensor by electrostatic discharges. Any variation introduced by the user to the supplied equipment may degrade the instrument's EMC performance. [. . . ] 350 hours DIMENSIONS 150x30x24 mm (5. 9x1. 2x0. 9") WEIGHT 85 g (3 oz. ) ACCESSORIES: HI76504/P4 1. 4V battery (4 pcs) HI 7030P Calibration kit 12. 88 mS/cm @ 25°C (2 x 30 mL) HI 7031P Calibration kit 1413 µS/cm (2x 30mL) HI 7032P Calibration kit 1382 ppm (mg/L) @ 25°C(2x 30mL) HI 7038P Calibration kit 6. 44 ppt (g/L) @ 25°C (2x 30mL) Visit our Internet Home Page: http://www. hannainst. com Authorized Dealer ISTRDISTWP 11/96 [. . . ]