User manual HANNA INSTRUMENTS HI 98114

[. . . ] WatercheckTM pH and TDS Meter pH and Conductivity Meter WatercheckTM1 OPERATION · Turn the meter on and select the measurement mode: pH or Conductivity/TDS. [. . . ] If you need to replace the electrode, use an hexagon key to remove the screw on the side of the probe before detaching it from the meter. BATTERY REPLACEMENT When the unit cannot be switched on or the display segments fade, it is necessary to replace all 3 x 1. 5V batteries. Batteries should only be replaced in a safe area using the battery type specified in this instruction manual. Loosen the upper screw and slide off the cover on the back of the meter. It is recommended to recalibrate the instrument whenever the batteries are replaced. RECOMMENDATIONS FOR USERS Before using these products, ensure that they are entirely suitable for the environment in which they are used. Operation of these instruments in residential area could cause unacceptable interference to radio and TV equipments, requiring the operator to take all necessary steps to correct interferences. Any variation introduced by the user to the supplied equipment may degrade the instrument's EMC performance. To avoid electrical shock, do not use these instruments when voltage at the measurement surface exceeds 24VAC or 60VDC. To avoid damage or burns, do not perform any measurement in microwave ovens. pH CALIBRATION · Turn the meter on and set the switch to the pH mode. [. . . ] 290 hours ENVIRONMENT 0 to 50ºC (32 to 122ºF) max 95% RH non-condensing DIMENSIONS 194x29x15 (7. 6x1. 2x0. 6") WEIGHT 70 g (2. 5 oz. ) ACCESSORIES HI 771P pH 7. 0 and 1410 µS/cm calibration solutions (20 mL each) and screwdriver (WatercheckTM) HI 773P pH 7. 0 and 1380 mg/L calibration solutions (20 mL each) and screwdriver (Watercheck TM 1) HI 70300M Storage solution, 230 mL HI 1281 pH and Conductivity/TDS replacement probe WatercheckTM is a Trademark of "Hanna Instruments" Visit our Internet Home Page: http://www. hannainst. com Authorized Dealer ISTRWATCR2 07/97 [. . . ]