User manual HANDHELD SYSTEMS HUSKY FS3

[. . . ] You must fit the battery pack and charge it before use; refer to SETTING UP for instructions. 0 Del No 5 6 7 8 9 18 3 Yes 9 10 C H N T Y D I O U Z PgDn 17 PgUp A F L R W B G M S X E K Q J P V 11 12 13 16 15 Sp Clr 14 Note: Keyboard and connector layouts vary on certain models. 2a On some models a single connector is provided, combining PORT 1 and PORT 2 (serial ports). 3 CONTACTS: on the rear of the unit - connect to the HUSKY FS Communications & Charging Rack (FS CCR), if this interface option is fitted. [. . . ] Note: If non-rechargeable alkaline batteries are fitted, you must select No. · Press J to select Battery capacity. Use G or H to adjust the value to 1600 mAh for a NiCd battery, or 2100 mAh for a NiMH battery. · Use J to select Charging Authorisation, and H to select Level 4 in APM (or Level 3 in FPM). Note: If non-rechargeable alkaline batteries are fitted, you must select Level 1. Charge the battery: press P to turn off the FS3 and leave it connected to the FS3 AC Adaptor or Rack to charge for at least 8 hours (APM or FPM) or overnight (SPM). Note: If non-rechargeable alkaline batteries are fitted, you must skip step 9. Note: After an application has been loaded into FS3, access to SETTING UP functions may be different. Refer to instructions provided with your application. CONTROLS Note: Your application's user instructions may supplement the following information. Turning on and off Press P to turn on, or off. To conserve power, the FS3 turns off automatically if you have not pressed any keys for a short while. Screen contrast Adjust the screen contrast for optimum readability, especially at temperature extremes. Hold down either S (SHIFT) key and press G to increase contrast or H to decrease contrast. Screen backlight In low ambient light, press L to turn the backlight on. You may need to press L at the same time (depending how your FS3 is set up). The backlight turns off automatically after a short time, to conserve power. Data entry To type numbers or letters, press the appropriate keys. To delete characters you've just typed, press the B (BACKSPACE) key. To select the characters or functions shown above the keys, hold down either S (SHIFT) key and then press the appropriate key. Moving the cursor Software applications will normally allow you to move the cursor a character or line at a time, using the arrow keys: I, J, G and H. To move the cursor up or down several lines, use Q and R. Resetting the FS3 Caution: Resetting the FS3 may lose your recent data entries. You should not need to reset the FS3 in normal operation - use this procedure in emergency only. Report the problem to your system provider. If the FS3 locks up or fails to operate, you MAY need to reset it as follows: Refer to the previous section SETTING UP. If this fails, try another charged battery pack (see Replacing the Battery). If this does not help, contact your system provider for assistance. LOADING SOFTWARE Your system provider may have already loaded the application software before issuing the FS3 to you. Software is normally loaded onto an FS3 by downloading files from a PC. For further details, please consult your system provider or the FS3 System Developer's Guide (or instructions provided with the application software). THE BATTERY The FS3 is designed for use with a rechargeable battery pack. Non-rechargeable alkaline batteries are not generally recommended for use with the FS3, except for light duty applications with no peripheral loads. [. . . ] In general all cables must be high quality, shielded, correctly terminated and normally restricted to 2 metres length. HUSKY AC adaptors employ special provisions to avoid radio interference and should not be altered or substituted. Unapproved modifications or operations conflicting with these instructions for use, may void approvals by the authorities to operate the equipment. USA Radio interference, FCC Statement NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ]