User manual HAMPTON BAY HBX050

[. . . ] However, the maximum amps of all devices on that fuse or circuit breaker can not exceed the amps of the fuse or circuit breaker. If the air conditioner has a serial plate rating of 115 volts and greater than 7. 5 amps it must have its own fuse or circuit breaker, and no other device or unit should be operated on that fuse or circuit breaker. If the air conditioner has a serial plate rating of 230 volts it must have its own fuse or circuit breaker, and no other device or unit should be operated on that fuse or circuit breaker. The location of the serial plate that applies to this model can be found on the back page of this manual. 1 WARNING 1 Expanded Polystyrene (white foam) 1. [. . . ] 10). 9 Top Bar Level Bottom Filler Panel Track Filler Board (Optional) Caution: Do not drill a hole in bottom pan. Unit is designed to operate with approximately 1/2" of water in bottom pan. Bracket SIDE VIEW 24 5 10 Foam Seal Upper Window Sash Installation in window 19" to 22" wide (Do not attach filler panels for this application) 1. Fasten lower window sash to window frame using finishing nails, wood screws, or "L" brackets. If filler is required on sides of air conditioner, cut foam seal to size and fill both sides. Cut foam seal to width of window and install between upper and lower window sash (Fig. 10). Lower Window Sash 5/8" Wood Screw 5/8" Wood Screws Wood Sill Filler Panel INSIDE VIEW OPERATION 3. MECHANICAL CONTROL PANEL Pictured control panel is similar to your panel. 4. Selects desired function of unit, cooling with continuous air circulation or air circulation without cooling. Thermostat: Controls unit thermostat, which regulates room temperature by automatically turning compressor on and off. The pictured control panel is similar to your panel. Set Temperature /Timer Display Cooling Operation 1. If room becomes too cool for comfort, turn thermostat counter-clockwise until compressor turns off (air circulating fan will remain in operation). When desired comfort level is reached, Master Control may be turned to a lower setting. To turn the unit off, or in the event of a power interruption, turn Master Control to OFF. Temperature /Timer Hour Controls Timer Control Fan Speed Control Air Circulation Without Cooling To circulate and filter air: 1. Caution: If air conditioner is shut off, wait a minimum of three minutes before restarting. Mode Control Power Control 7 Power Control The Power Control turns the unit on and off. Fan Speed Control The Fan Speed Control has three settings: High, Low and Auto. The settings are adjusted with the Fan Speed button, each time the button is depressed it changes the setting. When the COOL mode is selected, the unit will circulate and cool the air. If the FAN mode is selected, the unit will only circulate the air. OPERATION 5. FRONT PANEL 11 Remove screw from both sides of cabinet 12 Air Filter Adjustable Louvers Note: Failure to keep air filter clean will result in poor air circulation. Proper use and care of your air conditioner will help ensure longer life of the unit. It is recommended to have the unit inspected annually, as well as having the coils and condensate water passages cleaned. Expense of the annual inspection is the consumers' responsibility. Decorative Front Decorative Front Removal 1. Gently pull forward while grasping both sides of the decorative front. To replace the decorative front, line up the top and bottom and sides, and gently press into position. [. . . ] This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state. No warranties are made for units sold outside of the above stated areas. Your distributor or final seller may provide a warranty on units sold outside of these areas. How to Obtain Warranty Service or Parts Service for your room air conditioner will be provided by CareCo, a division of the manufacturer with authorized independent servicers nationwide. Note: Before calling for service, carefully read the Installation and Operating Instructions booklet. [. . . ]