User manual HAMA ROC6309

[. . . ] Method A ­ Fast programming with 1-digit subcode Before you start programming, you must find the subcode of the set to be controlled. Hold down the SETUP key until the red indicator light blinks and then remains lit (the indicator light remains on for a few seconds to give you the time to proceed with the following steps. The indicator lamp flashes to signal that this time is almost up, and then goes off). Press the key that corresponds to the type of equipment you want to control: TV: Television Set, DVD: DVD Player, Video Recorder, VCR, AUX, SAT: Satellite Receiver, Cable Receiver, ADSL Box, DVBT Receiver, . [. . . ] Method C ­ Programming by means of code retrieval Should none of the codes work, you still have the possibility of retrieving the appropriate code without having to perform any input. Hold down the SETUP key until the red indicator light blinks and then remains lit (the indicator light remains on for a few seconds to give you the time to proceed with the following steps. The indicator lamp flashes to signal that this time is almost up, and then goes off). Press the key that corresponds to the type of equipment you want to control: TV: Television Set, DVD: DVD Player, Video Recorder, VCR, AUX, SAT: Satellite Receiver, Cable Receiver, ADSL Box, DVBT Receiver, . Direct the remote control towards the set and try to switch it off by pressing the key G. If the set you want to control switches off, press OK to memorise the code. Should the set not switch off, press key G as many times as required (up to 200 times), until the set switches off. Between pressing the keys, be sure to leave enough time for the indicator light to go out and then relight (about 1 second). Proceeding this way will enable you to see whether the set responds or not. Check of the programming: In principle, your set is ready for receiving the remote control commands. Check your remote control for proper functioning by performing the test described on page 2. Try out other remote control keys to find out the range of functions you can control. If you think that not all of the keys are active, repeat the procedure of this programming method to find out the code supporting a wider range of features. Method D ­ Automatic code search With this method, the remote control scrolls through the full code list by sending an IR signal to the set to be controlled remotely. Hold down the SETUP key until the red indicator light blinks and then remains lit (the indicator light remains on for a few seconds to give you the time to proceed with the following steps. The indicator lamp flashes to signal that this time is almost up, and then goes off). Press the key that corresponds to the type of equipment you want to control: TV: Television Set, DVD: DVD Player, Video Recorder, VCR, AUX, SAT: Satellite Receiver, Cable Receiver, ADSL Box, DVBT Receiver, . After a few seconds, the remote control begins to scroll through the whole code list included in the library (at a rate of roughly 1 code per second). Press the P+ , G or B key once again to slow down the test speed (1 code every 3 seconds). As soon as the set changes channels (or turn off, or Start to play the disk), you must press OK to save the code and stop the remote control scrolling through the list. [. . . ] The number which made the indicator lamp blink is the first of the four figures comprising your code, write it down. For a television or a satellite receiver: switch on and, for example, press 2 to change channels, etc. Try other remote control keys to find out the range of functions you can control. If you think that not all of the keys are active, try the programming Method B or C. [. . . ]