User manual HAIER XQJ50-31

[. . . ] If your old washer is not being used, we recommend that you remove the door. Do not use washer to wash clothes soaked, spotted or washed in gasoline, dry cleaning solvents or any other explosive or flammable substances that could ignite and explode. Clothes or rags used to clean flammable or explosive materials should not be washed in the washer till all traces of this material has been removed, to avoid an accident. Do not operate your washer when parts are missing or parts are broken. [. . . ] This dispenser is only designed for liquid form. 8 XQJ50-31 manual 10/22/01 11:30 AM Page 10 English Bleach Dispenser: · Bleach dispenser is located on front corner under the loading door. · Pour in recommended amount of bleach into dispenser during the first wash fill. Note: Use only liquid bleach in dispenser. Warning: · Be careful not to spill undiluted bleach on the washer cabinet or your clothes. As it is a strong chemical, it may damage some of your clothes or the finish of the washer if not properly diluted. · Use the manufacturer's chart, on product container for recommended use of liquid or powder bleach. Temperature Control: WASH/RINSE Temperature TEMPERATURE WASH RINSE COLD COLD WARM COLD HOT COLD WARM WARM 9 XQJ50-31 manual 10/22/01 11:30 AM Page 11 English · Depending on what types of clothes you are washing, select the desired temperature setting. See the garment for proper temperature that is recommended by garment manufacturers. You can wash and rinse from five temperature combinations: WASH/RINSE Hot/Cold Warm/Warm Warm/Cold Cold/Cold TYPES OF FABRICS Sturdy whites & colored fabrics such as work & play clothes, soiled fabrics Delicate & colored fabric Soiled, permanent press, silks, woolens, nylon & acrylic Non-colors Fabrics, lingerie with light or normal soil clothes & special care fabrics Note: Hot water needs to be at a temperature of at least 120°F ­ 140°F. (49°C- 60°C) for the soap to dissolve and to avoid soap residue remains on clothes. Normal Operating Sounds The following sounds are normally heard during the operation of the washer: · Tumbling sounds: This is normal as the heavy wet clothes in the Washer are continuously being tossed around. · Air rushing noise: This happens when the Washer tub spins at very high RPM. · Wash and Rinse cycles going on and off will also make clicking sounds. 10 XQJ50-31 manual 10/22/01 11:30 AM Page 12 English Lint Filter · A self-cleaning lint filter works throughout the wash cycle to constantly remove lint and other residue from the water. As water passes from the outer tub to the inner tub, water is forced through the bottom of the lint filter. · Clothes are grayed or yellowed: this is due to not pouring enough detergent for large loads. · Clothes are ripped & have holes/excessive wear & tear: this is due to sharp objects such as pins and belt buckles left in pockets. Never add undiluted bleach to wash. 15 XQJ50-31 manual 10/22/01 11:30 AM Page 17 English INSTALLATION INSTRUCTIONS Tools and Materials Required You will need to have following tools to help you in the installation of your Washer: · Scissors · Phillips Screwdriver · Standard Screwdriver · Pliers · Wrench · Tape Measure · Gloves · Level Accessories Supplied 1. Flat Water Inlet Hose Washers Quantity 2 1 1 1 4 1 2 3 4 5 16 XQJ50-31 manual 10/22/01 11:30 AM Page 18 English Unpacking Your Washer · Remove all packing materials. This includes the foam base and all adhesive tape holding the washer accessories inside and outside. · To remove the cardboard shipping brace from the washer, step on the cardboard base and tilt the washer back, until the security shipping screw is free from the base. · Inspect and remove any remains of packing, tape or printed materials before using the washer. Leveling Your Washer · Your washer has 4 leveling legs; which are located on the four bottom corners. After properly placing your washer in its final position, you can level your washer. · Leveling legs can be adjusted by turning them counterclockwise to raise your washer or turning them counter clockwise to lower your washer. 17 XQJ50-31 manual 10/22/01 11:30 AM Page 19 English Steps for Installation · Select a suitable location for the washer on a hard even surface away from direct sunlight or heat source e. g. Any floor unevenness should be corrected with the leveling legs located on the bottom corners of the washer. You must not place washer where the temperature is at below freezing. Installing Your Washer: Read install instructions carefully before installation. [. . . ] Note: Where a standard two-prong outlet is encountered, it is the personal responsibility and obligation of the consumer to have it replaced with a properly grounded three-prong outlet. X Extension Cords: We do not recommend that you use an extension cord. Power Interruptions Occasionally there may be power interruptions due to thunderstorms or other causes. If outage is for a prolonged period, clean washer before using it again. 20 XQJ50-31 manual 10/22/01 11:30 AM Page 22 English Limited Warranty Full ONE Year Warranty For 12 months from the date of original retail purchase, Haier will repair or replace any part free of charge including labor that fails due to a defect in materials or workmanship. Limited Warranty After one year from the original retail purchase date, Haier will provide a part at no cost, as indicated below, to replace said part as a result of a defect in materials or workmanship. All other costs such as labor, trip charge, etc are the responsibility of the owner. [. . . ]