User manual HAIER HW-05LN03

[. . . ] TEMPERATURE 5 4 3 2 1 MIN COOL 6 7 8 9 10 MAX COOL FAN ONLY HI LOW SPEED ON OFF POWER Wait 3 Minutes Before Restarting HW-05LM13 HW-05LN03 001051 1 2 3 3 4 4 5 6-7 6 6-7 8-12 9 9-10 11-12 13-14 15 Installing unit into a window Wall installations 5 2-way airflow TEMPERATURE 5 4 3 2 1 MIN COOL 6 7 8 9 10 MAX COOL FAN ONLY HI LOW SPEED ON OFF POWER Wait 3 Minutes Before Restarting easy access filters control panel MODEL: HW-05LM13 HW-05LN01 5. [. . . ] If storm window presents interference, fasten a 50mm wide wood strip(not included) (OUTER SILL) to the inner window sill across the full width of the sill. The wood strip should be thick enough to raise the height of the window sill so that the unit can be installed without interference by the storm window frame (STORM WINDOW FRAME) or wood strip (OUTDOORS) to help condensation to drain properly to the outside. Install a second wood strip (approximately 150mm long by 38mm wide and same thickness as first strip) in the center of the outer sill flush against the back off the inner sill. If the distance between STORM WINDOW FRAME and WOOD STRIP MOUNTED ON TOP OF INNER SILL is more than 25mm, two of wood strip are not necessary. I N D O O R S INNER SILL O U T D O O OUTER R SILL S WOOD STRIP MOUNTED ON TOP OF INNER SILL 25mm MAX. 19mm CLEARANCE STORM WINDOW FRAME O U T OUTER D SILL O O R S INNER SILL Hereinbefore is just for the demonstration, please adjust the data according to the actual structure and dimension of the window. WOOD STRIP I FOR BASEPAN N ANGLE D O O R S 2 3 10 11 Also the side louvers should not be blocked. (See fig. #2) 12 E TEMPERATUR 5 4 3 2 1 MIN COOL 6 7 8 9 10 MAX COOL FAN ONLY LOW PEED OFF POWER Always unplug your air conditioner before cleaning. The air filter behind the front grille should be checked and cleaned at least once every 2 weeks or more often if necessary. [. . . ] To clean the front panels or the cabinet DO NOT use harsh chemicals, abrasives, ammonia, chlorine, bleach, concentrated detergents, solvents or metal scouring pads. Always use a soft cloth dampened with water or mild soap and water solution to wipe the front of the cabinet. 13 14 (see page 6) 15 [. . . ]