User manual HAIER HVTM12BSS

[. . . ] Model number Serial number Date of purchase Staple your receipt to your manual. Note: This figure is only a sketch and may differ from the actual product This includes the base and all adhesive tape holding the wine cellar accessories inside and outside. Inspect and remove any remains of packing, tape or printed materials before powering on the wine cellar. To assure your wine cellar works at the maximum efficiency it was designed for, you should install it in a location where there is proper air circulation and electrical connections. [. . . ] Gently move wires aside and loosen the 3 screws using a Phillips Head Screwdriver. Insert the screws through the holes in the bracket and then into the predrilled holes on the bottom of the wine cellar (see image) 3. You can set the temperature of your wine cellar at any setting you desire. By pressing the ( ^ ) temperature button on the display you can increase the temperature and pressing the ( v ) temperature button will lower the temperature. please note that the actual cabinet temperature in a thermoelectric unit is dependent on the ambient temperature. You may set the cabinet temperature within range but the unit may not reach the preset temperature. For this model, when the ambient temperature is 77°, the lowest temperature that can be reached is 50-52°. When ambient temperature is 73°, the cabinet temperature can reach approximately 46-48°. When the ambient temperature is below the pre-set temperature, the cellar will not operate until the ambient temperature increase to higher than the pre-set temperature. Thermoelectric (also referred to as semiconductor) wine cellars do not use a compressor and therefore create minimal noise and vibration. Besides being extremely quiet, the lack of vibration will prevent bubbles from forming in stored wine. In addition thermoelectric units offer high reliability and low maintenance while precisely maintaining the preset temperature for storing wine. To maintain proper product cooling and longevity the fan filter should be removed and cleaned every 6 months, or sooner, to remove dirt, dust and hair that can accumulate causing the cooling system to not function properly. ALWAYS UNPLUG THE UNIT PRIOR TO CLEANING THE FAN FILTER There are two effective methods to clean the external fan filter: · A vacuum cleaner can be used to remove the dirt, dust and hair that has built-up. ⷠAlternatively compressed air, similar to what is used on a computer keyboard, can be used to clean the fan filter. Please be sure to follow the directions of the compressed air container to avoid damage or personal injury. Warning: To avoid electric shock always unplug your wine cellar before cleaning. Caution: Before using cleaning products, always read and Prepare a cleaning solution of 3-4 tablespoons of baking soda mixed with warm water. Use sponge or soft cloth, dampened with the cleaning solution, to wipe down your wine cellar. ⷠRinse with clean warm water and dry with a soft cloth. [. . . ] For the name of the nearest service center please call 1-877-337-3639. Damage from misuse, abuse, accident, alteration, lack of proper care and maintenance or incorrect current or voltage. Damage from service by other than an authorized dealer or service center. THIS LIMITED WARRANTY IS GIVEN IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED OR, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE The remedy provided in this warranty is exclusive and is granted in lieu of all other remedies. [. . . ]