User manual HAIER HPM09XC5 11-04

[. . . ] Dealer's Phone Number: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TABLE RECEPTACLE RATED VOLTS AMPS 125/60 15 AND 20 FUSE TYPES 15 250/60 20 30 WALL OUTLET FUSE SIZE TIME DELAY FUSE (or circuit braker) 15 Plug 20*15 Plug 20* Plugm 30 1 English SAFETY PRECAUTIONS WARNING: Following these basic precautions will reduce the risk of fire, electrical shock, injury or death when using your air conditioner. 1) Air conditioner must be connected to proper electrical outlet with the correct electrical supply. (see table previous page) Proper grounding must be ensured to reduce the risk of shock and fire. If you do not have a three-prong electric receptacle outlet in the wall, have a certified electrician install the proper receptacle. Do not operate air conditioner if power cord is frayed or otherwise damaged. [. . . ] Push the round Window Panel Adapter through the rear of the Plastic Panel. Line up the holes and tighten the Adapter with 4 screws that are included in the kit. Connect exhaust hose to the unit by inserting the hose connector that is attached to the hose into the exhaust. Move the unit to the window, extend the hose and attach the other end of the hose to the window. Align the tabs on the hose and window panel adapters and fasten them together. A B Hose Connector Exhuast Hose Hose Connector 6 English Operation NOTE: Wait for 24 hours to turn on air conditioner if the unit has been tilted for any reason. After a normal shut down wait for 3 minutes before restarting the unit so as to complete the compressor cycle. Do not use any other electrical appliances on this line or you may trip the fuse. Do not place the air conditioner in direct sunlight or close to any heating appliances (eg. Keep the unit free of any obstructions such as drapes, curtains, blinds, etc. If the unit is not being used for a long period of time, remove the plug from the water drain pipe and drain out any condensed water. CONTROL PANEL OPERATIONS 1. Timer Control - Timer Settings 1-8 Hours If you turn the dial to CONT this will override the timing control and the unit turned to the Off position. By turning the dial to one of these numbers the unit will turn off automatically when the dial to one of these numbers the unit will turn off automatically when the dial returns to the position. Fan Speed Control - Fan/Cooling This dial operates in FAN ONLY or COOLING modes to set fan speed. Cooling Control - Turn clockwise to CONT for maximum cooling position This dial sets the desired cooling temperature and will turn the compressor off automatically once the desired temperature is reached, the fan will continue running. When the room temperature rises the compressor will come on and resume the cooling operation. If you turn the dial fully clockwise to CONT this is maximum cooling position. Note: The unit is fitted wth and overloaded protect-system which means when it is switched off and turned on immediatly the compressor will not operate for a few minutes but will resume operation after this time. 2 1 3a 7 English Product Specification Voltage and Frequency Input Power Cooling Capacity Moisture Removal (pints/day) Coolant Timer Operating Temperature Range Unit Dimensions (WxDxH) (inches) Net Weight lbs. approximate Power Cord Exhaust Hose 115V / 60Hz 950 W 9000 BTU 80 R22 / 1. 12 lbs 8 Hours 61°F - 100°F 17 3/32 x 15 3/4 x 30 5/16 435mm x 400mm x 770mm 65 lbs. [. . . ] · On extremely hot & humid days, air conditioners may take a little longer to cool. Put air conditioner in cool mode. 9 English Limited Warranty This warranty covers all defects in workmanship or materials for: 1. The mechanical and electrical parts (including labor costs) contained in this Haier product, for a period of 12 months, from the date of purchase, (commercial or rental application, the warranty is 90 days). The sealed system and compressor contained in this Haier product is for a period of 5 years, from the date of purchase (excluding labor costs after the initial 12 month period). [. . . ]