User manual HAIER HPIM25SS

[. . . ] Keep for your records to obtain Warranty Service Thank you for using our Haier product. This easy-to-use manual will guide you in getting the best use out of your appliance. __________________________ Model number __________________________ Icemaker serial number __________________________ Date of purchase Staple your receipt to your manual. Wiring and Grounding Instructions This appliance must be plugged into at least a 15 AMP 110-115 VOLT 60 Hz GROUNDED OUTLET. [. . . ] Leave an 8-inch clearance on all sides of the icemaker for proper ventilation. It is best to fill the water reservoir with water of room temperature or lower. Open the top cover, take out the ice storage basket and fill the water reservoir with drinkable (tap, purified or bottled) 2. Make sure that the water level does not reach above the level mark or the bottom of the ice storage basket. Note: During the operation process, if the level of water in the water reservoir becomes too low, the machine will automatically stop operating and the "Add Water" indicator will display on the LED. Select the desired size of ice cube by pressing the S or L ice selector button. The next cycle of 9 ice cubes is complete (based on water temperature, ambient room temperature and selected ice cube size). Water is pumped from the water storage tank to the water box, which may take up to 1 minute. The icemaking cycle begins when the evaporator rods are dipped into the water box. It will take approximately 5-13 minutes for each icemaking cycle, depending on the size selected. After the cycle is finished, the water box will tilt forward and the remaining water will flow back into the water storage tank. Note: If the room ambient temperature is below 60° F, then small ice cube sizes are suggested to prevent ice cubes from fusing together. Approximately 60 seconds later, the water box will tilt backwards and the ice pusher will push the ice into the ice storage basket. After the water box flips back to its original position, the next icemaking cycle will begin. When the maximum capacity of ice cubes is collected and the ice reaches the temperature sensor, the icemaker will automatically stop operating. If more ice is needed, remove the ice from the ice storage basket; then replace the basket into the machine, making sure that the basket is placed back to its original position. To continue making ice, check that there is water in the water storage tank. If there is no water in the water storage tank, then no water will be pumped into the water box, and the operation will stop. Fill the water storage tank with water, and then press the "ON" button for the icemaker to begin operating again. Allow the refrigerant inside the compressor at least 3 minutes to settle before restarting. If the compressor stops for any reason such as water shortage, too much ice, power off, etc. Before using your icemaker, it is strongly recommended that you clean the icemaker thoroughly. [. . . ] EXCEPTIONS: Commercial or Rental Use warranty 90 days for labor 90 days for parts No other warranty applies. The mechanical and electrical parts of the appliance which serve the functional purpose of this appliance are covered for a period of 12 months or as stated above. The limited warranty does not cover any credit or refund for any loss or injury caused by the product or defects to the product including but not limited to incidental or consequential damages. Any mechanical or electrical part that proves to be defective in normal usage during the specified warranty period will be repaired or replaced at Haier's discretion. [. . . ]