User manual HAIER HMS-1250

[. . . ] Drain hose Water inlet valve Power cord Back cover Back cover screws Transportation bolts Make sure that the transport bolt are removed. Hold the plug and not the electric cable when unplugging the power supply. Keep away from heat sources and direct sun light to prevent plastic and rubber components from aging. [. . . ] Fix the drain hose to the clip at the back of the washing machine to prevent it from dropping off. If the drain hose is placed on the ground or if the pipe is at a height of less than 80cm, the washing machine will continuously drain while being filled (self-siphoning). Before connecting to the power supply, check: ¬ The socket is adequate for the maximum power of the washing machine (For safety, fuses in the power circuit should be rated for no less than 15A). ¬ The power outlet should be capable of accepting the washing machine plug. A B C ¬ Program knob ¬ Power Switch ¬ Start/Pause Button _By turning the knob clockwise/counterclockwise, the required program can be selected. _ When the washing machine is connected to the power socket and a program is selected, lightly touch this button to start operation. During a wash cycle, touch it lightly , operation will stop and the digits on the screen start blinking. To cancel a wash program during a wash cycle, touch this button, when the digits on the screen start blinking, press the Power switch, the program will be cancelled. Note: Different water temperatures and spinning speeds can be set for different laundries. F ¬Delay Button Touch this button lightly, the washing machine will start operation after a period of time and the corresponding indicator will go on. After the button is set, press the Start/Pause button to start countdown of the set time (the time is displayed on the screen until the program ends). Note:The delay time must be longer than the program time;otherwise, the washing machine will start the wash program directly. _Open the drawer, three compartments can be 2 seen: 3 1 Compartment 1: Prewash detergent Compartment 2: Detergent for programs 1 to 8 Compartment 3: Softener, conditioning agent, perfume, etc. _Information as remaining wash time, temperature and speed setting and error messages will be shown here. Note: After power is switched on, the display will go on and the remaining wash time decreases. As the water pressure and temperature may differ, the remaining time maybe adjusted accordingly. When the laundry is not balanced during spinning, the time may be automatically prolonged. E+F: Combination for keyboard lock After a programme is started, press these two keys simultaneously, the sign "LOCK" and the remaining washing time are displayed on the LED alternately. [. . . ] Modern detergents can wash with very good result already in lower temperature than 60°C. Only use higher temperature than 60°C for heavily soiled laundry. Follow the dosage recommendation on the detergent package to avoid using too much detergent. [. . . ]