User manual HAIER HI1MK

[. . . ] Ice Maker with Power Cord Ice Container Plastic Water Supply Tubing with Plastic Nut Self-Tapping Screws (Qty-2) Pan Head Screws (Qty-2) Leveling Bracket Screw (Qty-1) Leveling Bracket (Qty-1) 8. Owner's Manual & Installation Instructions 1 2 3 4 5 6 10 7 8 9 11 12 13 2 English Installation Instructions 1. Unplug the refrigerator from the power outlet and move it out for easier access. Remove the freezer shelf by pushing the shelf to your left until the right side is free from the holes. [. . . ] (See fig # 10) Water Valve (10) (Figure 10) Plastic Nut Plastic Water Tubing (3) To Icemaker Fill Tube 5. Using a power drill with a Phillips-head bit, drive in the 2 supplied self tapping screws to attach the water valve to the right side of the refrigerator. # 11) Water Valve (10) (Figure 11) Factory Punched Holes Screws (4) 7 English Water Supply Connection WARNING This water supply installation is not warranted by the refrigerator or icemaker manufacturer. Follow these instructions carefully to minimize the risk of expensive water damage. Supplies Required for Installation: · Access to a household cold water line with water pressure between 20psi. To determine the length of the copper tubing needed, you will need to measure the distance from the ice maker inlet valve at the back of the refrigerator to your cold water pipe. Then add approximately 7 feet, so the refrigerator can be moved out for service. · A shutoff valve to connect the water supply line to your household water system. · A compression nut and ferrule (sleeve) for connecting the water supply line to the ice maker inlet valve. 1. Insert the brass compression nut and the ferrule (sleeve) onto the end of the copper water line as shown in the picture. 8 English 4. Now push the water supply line into the water valve inlet as far as it will go. Slide the ferrule (sleeve) into the valve inlet and finger tighten the compression nut onto valve. Now, screw rear access panel that covers compressor compartment back in place. # 12) Plastic Water Tubing to Ice Maker Fill Tube Steel Clamp Brass Compression Nut Ferrule (Sleeve) Copper Water Line Water Valve Bracket Valve Inlet Water Valve (Figure 12) Copper Water Line from Household Water Supply (Include enough tubing in loop to allow moving refrigerator out for cleaning. ) Power cord Plastic water tubing Coper water line 5. With the supplied steel clamp and hex head screw, secure the water supply line to the rear panel of the refrigerator. 9 English 6. Coil the excess water supply line behind refrigerator, as shown in fig. # 12 and arrange the coils so they do not vibrate or wear against other surfaces. Turn ON the water supply at the shutoff valve and tighten any connections that leak. Important: It takes approximately 24 hours for the ice maker to produce ice. Discard ice made in the first 24 hours. Automatic Ice Maker Tips Remember that the water quality determines your ice quality. To stop the ice maker, lift the wire arm until it clicks and locks in the OFF (raised) position. If your model has an adjustable freezer shelf, place the shelf so that when the ice container is full, the ice will hit the wire signal arm. ON Ice Maker Tips: · Ice stored too long may develop an odd flavor. [. . . ] ·Damage to product caused by accident, fire, floods or Acts of God. THIS LIMITED WARRANTY IS GIVEN IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED OR, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. The remedy provided in this warranty is exclusive and is granted in lieu of all other remedies. This warranty does not cover incidental or consequential damages, so the above limitations may not apply to you. [. . . ]