User manual HAIER HF-220WAA

[. . . ] The instructions contain important information which will help you get the best out of the appliance and ensure safe and proper installation, use and maintenance. Keep this manual in a convenient place so you can always refer to it for the safe and proper use of the appliance. If you sell the appliance, give it away, or leave it behind when you move house, make sure you also pass on this manual so that the new owner can become familiar with the appliance and safety warnings. The presence of this symbol on the product, accessories or materials that goes with this information indicates that at the end of its useful life the product or its electronic accessories (ex. [. . . ] Clean and dry any water splashes and stains with soft cloth in time to prevent rust. Do not place the freezer where the temperature is too low (under 5°C). preparation prior to use Remove all package parts, the foam base and the adhesive tape fixing accessories. Place the freezer in a proper location (please refer to Placing Environment). Clean the inside and outside of the freezer before use (please refer to Defrosting and Cleaning) After the appliance has been leveled and cleaned, let it remain idle for at least 6h before switching it on so as to ensure its normal running. Display will show you code dF and it means that the freezer is in defrosting condition. The alarm led F and acoustic signal will indicate that the temperature inside freezer is not sufficiently cold for storage of foodstuffs. Pressing the button A3 to choose the "Alarm" function then press the button A4, you can disable acoustic signal, but warning light will be on till freezer will reach the temperature of -12°C. When display show the temperature of -12°C, alarm condition will stop automatically and freezer will be ready for food storage. Check the Controls Panel: Touch any button on the display screen and check whether the temperature area and the selected icon can be lightened. During temperature setting two numbers on display show the point set in flashing mode. Additional pressing on this button modify the set-point in cycling and decreasing mode from ­14°C to ­26°C. If no action is done on the OK button within 5 sec, the set point will be stored automatically. After the temperature is set, the two numbers on display come back to the freezer temperature visualization. Press the button A4 for 5 sec to turn off the power of the freezer; do it again the power will be turned on. Before any cleaning operation, make sure to disconnect the appliance from the power supply by pulling out the plug, it isn't enough to turn off the appliance pushing power button. Freezer functions FAST FREEZING: Press the button A3 to choose the "S. FRZ" function, then press the button A4, you can activate fast freezing of fresh food. The dedicate light E switches on to indicate that the function is on, and activation of the function is achieved. For fast freezing a small amount of food, this function is recommended to be activated 2 hours before inserting food; if you have a large amount of food to freeze at one time, it is recommended that the function be activated 24 hours before inserting food Function will stop automatically after 24 hours or manually. FUNCTION ECO: When the screen is unlocked, press the button A3 to choose the "ECO" function, then Press the button A4, you can activate the function of energy saving, setting temperature within the range of -18°C and -14°C. If the temperature has been set at -19°C or lower, it will be set automatically at -18°C when the ECO function is on. [. . . ] When cleaning the display screen and other electrical appliances, do use dry cloth. stopping use If the freezer will not be used for an extended period, please unplug the power cord and clean it with the method described above. Keep the freezer door open to prevent any food remaining in the compartment from producing bad odors. To ensure the service life of the appliance, it is recommended that the freezer not be turned off unless it is necessary. [. . . ]