User manual HAIER HDG 5000 AW

[. . . ] this will simplify the installation and ensure the dryer is installed correctly and safely. NOTE: The electrical service to the dryer must conform with local codes and ordinances and the latest edition of the National Electrical Code, ANSI/ NFPA 70 or in Canada, CSA C22. NOTE: The gas service to the dryer must conform with local codes and ordinances and the latest edition of the National Fuel Gas Code, ANSI Z223. This dryer is not recommended for commercial application such as restaurants, beauty salons, etc. [. . . ] The actual time can be changed in the Manual Drying cycles by touching "More Time" or "Less Time" pads. - Timed Dry: Use this cycle to dry heavy weight items like comforters, etc. - Touch Up: This cycle removes wrinkles from items such as clothes packed in a suitcase or wrinkles in items from being left in the dryer too long. auto-Dry (Sensor Dry) Cycles: · "Auto-Dry (Sensor Dry) cycles" pad will let you select your desired dry cycles. For your convenience, there are 6 fabric care dry cycles programmed in this mode: Bulk Items, Heavy, White, Normal, Delicate, Press Free. If manual dry is selected, touching the pad will cause two beeps to sound. First select sensor dry cycle then adjust the dry level to how much you want to dry the load. Note: Dry level selection can only be made while using the Auto (Sensor) Dry Cycles. For Auto Dry Cycles the temperature can be selected only for settings below the default setting, Air Dry cannot be selected. This controls the volume of beep when you touch any pads on the control panel or when the dry cycle is completed. This option can only be used with heavy, bulky items, White and Normal cycle. This convenient feature helps keep wrinkles from setting when you cannot unload the dryer at the end of a cycle. The dryer will stop and then rotate for a brief period every few minutes. This feature will work for 1 hour after the drying program is completed. Stop the setting at any time by pressing the wrinkle pad or by opening the dryer door. more Time & Less Time Pad: (10) · Used to set time from 0 to 2 hours when Timed Dry, Rack Dry, Speed Dry or Touch Up cycles selected. damp Dry Signal (11) · If activated the dryer will beep when the load is approximately 80% dry. This will allow you to remove lightweight items that are dry or other items that you 21 This allows you to save a favorite cycle, set the desired settings and touch "Custom Program"pad for 3 seconds. To recall your custom cycle , touch the "Custom Program"pad before drying a load. To change the saved cycle, set the desired settings and "Custom Program"pad must be again programmed for 3 seconds. you can also program Anti-Bacterial , Wrinkle Saver and Damp Dry Signal. Function Light Indicator: (13) - Child Lock: You can lock the controls to prevent any selections from being changed or You can lock the controls after you have started a cycle. [. . . ] Dryer makes noise when drying: · Check for coins, loose change, buttons and other heavy objects that could be causing the noise. Full ONE Year Warranty For 12 months from the date of original retail purchase, Haier will repair or replace any part free of charge including labor that fails due to a defect in materials or workmanship. After only year from the original retail purchase date Haier shall provide a part at no cost, as indicated above, to replace said part as a result or a defect in materials or workman ship, Haier is solely responsible for the cost of the part. All other costs such as labor trip charge, etc are the responsibility of the owner. [. . . ]