User manual HAIER EDW125X1

[. . . ] Young children should be supervised to ensure that they do not play with the appliance. Avoid contact with the skin and eyes and keep children away from the dishwasher when the door is open. Check that the detergent receptacle is empty after completion of the wash cycle. During installation the power cord must not be bent or flattened excessively. [. . . ] Otherwise, the detergent may have already been used and the appliance may have already drained the wash water. If this is the case, the detergent dispenser must be refilled (See "Detergent and rinse aid"). Rotate the dial in a clockwise direction to the desired cycle setting. Turn the dishwasher back on using the Power button. 8 Wash cycle table Cycle Types of load Description of cycle Detergent (in dispenser/inside door) Rinse aid setting Heavy Very dirty dishes, pots and pans. (Not to be used with delicate items. ) Cold pre-wash Cold rinse Extended 50°C wash Hot rinse Drying 30 g ___ Normal (AS/NZS 2007) Normal load of dirty dishes, pots and pans. Standard daily cycle. Cold rinse Extended 50°C wash Hot rinse Drying 25 g / 5 g 5 Rinse For dishes that only require a rinse and dry. Hot rinse Drying ___ ___ Glassware Economic cycle for delicate items. Run immediately after dishes are used. Wash at 50°C Hot rinse Drying 15 g ___ Pre-Rinse Pre-rinse of dishes while waiting for a full load. Short cold rinse to prevent food residue from drying on the dishes. ___ ___ 9 Energy-saving and environmental tips Run the dishwasher when it is fully loaded to save on energy. Rather than run a full cycle for a half load, run the pre-rinse cycle, which will prevent odours from forming and food from caking onto the dishes. Choose the right wash cycle: the choice of cycle depends on the type of dishware, cookware and utensils being washed and how dirty they are. Use the right amount of detergent: if you use too much detergent, the result will not be cleaner dishes, but, rather, a greater negative impact on the environment. Maintaining your dishwasher After every wash, turn off the water supply to the appliance and leave the door slightly ajar so that moisture and odours are not trapped inside. Before cleaning or performing maintenance, always remove the plug from the socket. Do not use solvents or abrasive cleaning products to clean the exterior and rubber parts of the dishwasher. To remove spots or stains from the surface of the interior, use a cloth dampened with water and a little white vinegar, or a cleaning product made specifically for dishwashers. If you have to move the dishwasher, try to keep it in the vertical position. Do not lay the dishwasher on its right-hand side Never lift the dishwasher by the door handle Cleaning the door seals. One of the reasons that odours form in the dishwasher is that food gets trapped in these seals. When you go on holiday it is recommended that you run a wash cycle with the dishwasher empty and then remove the plug from the socket, turn off the water supply and leave the door of the appliance slightly ajar. This will help the door seals last longer and prevent odours from forming. 10 Cleaning and special maintenance Cleaning the filter assembly For the best performance and results, keep the filter assembly clean. The filter removes food particles from the wash water, allowing the water to be recirculated during the cycle. For this reason, it is a good idea to remove any food particles trapped in the filter after each wash cycle by rinsing the semi-circular filter and cup ("A") under running water. Is the rinse aid dosage correct? If, despite all these checks, the dishwasher still does not function and/or the problem persists, contact your nearest authorised service centre and provide them with the following information: 1. The model number (Mod. . . ) and the serial number (S/N. . . ), found on the side of the inner part of the door. 12 Installation 1. [. . . ] Do not return to Fisher & Paykel. 16 Customer Care Check the things you can do yourself. Refer to your User Guide and check: 1 2 your appliance is correctly installed you are familiar with its normal operation If after checking these points you still need assistance please refer to the following: If you need assistance. . . * Call your Fisher & Paykel retailer who is trained to provide information on your appliance, or if we can be of any further help, please contact our Customer Care Centre, Toll Free - 0800 FP CARE or 0800 37 2273 Email: customer. care@fp. co. nz Postal address: P. O. Box 58732, Greenmount, Auckland. Fax: (09) 273 0656 If you need service. . . * Fisher & Paykel has a network of independent Fisher & Paykel Authorised Service Centres whose fully trained technicians can carry out any service necessary on your appliance. Your dealer or our Customer Care Centre can recommend an Authorised Service Centre in your area. *If you call or write, please provide: name, address, model number, serial number, date of purchase and a description of the problem. [. . . ]