User manual HAIER DW12-HFE2

[. . . ] - This appliance cannot be installed outdoors, not even if the area in which it is installed is covered by a roof; it is also very dangerous to leave it exposed to the rain and elements. - Do not lean or sit on the door when it is open as this could over turn the dishwasher. - If the appliance malfunctions, turn off water supply to the appliance and disconnect the plug from the wall socket. - Appliances which are no longer being used must be made inoperable by cutting the power supply cord and removing the door lock. [. . . ] Adjust the upper basket to the higher level and you have more space to accommodate those taller pans and trays in the bottom basket. Shelf Lean tall glasses and those with long stems against the shelf-not against other items to be washed. The additional cup rack can be swivelled in or out as required(see fig. C). Knife rack The knife rack clips onto the side of the top basket, giving you the freedom to wash your large sharp knives separately and out of harm's way (see fig. D). Lower Rack Upper Rack Starting a wash cycle After having completed all of the installation steps in the preceding paragraphs, turn on the water all the way and press the ONOFF button (B) located on the control pannel. At this point, the appliance is on but you must wait a few seconds before programming the cycle setting. Setting and Starting a wash Cycle Select the desired cycle by pressing the selector button (I). Each Setting the Wash Cycle with a Delayed Start Time By pressing the "D" button (see close-up view-'Control panel") the start of wash cycle can be delayed for between 1 to 12 hours. Each time the button is pressed, the display (C) will show the number of hours for the delay period. After selecting the wash cycle, a short acoustic signal will sound and after a few seconds, the delay time on the display will blink, This indicates that the countdown has begun. After the time has lapsed, the cycle will start. Load for 12 Standard Settings time the button is pressed, one of the "J" cycle indicator lights will come on in succession. Choose the wash cycle you feel is most appropriate for the type of dishes that need washing (consult the wash cycle table contained in this manual. After a few seconds, the wash cycle has begun and can no longer be changed. If necessary, read the paragraph entitled "Cancelling or modifying a cycle" . NOTE: During the delay period, it is preferable not to change any of the settings, If this is necessary, all of the settings must be cancelled by pressing the ON/OFF button (B). At this point, all of the steps for "setting the wash cycle with a Delayed Start Time" and "Setting and Starting a wash cycle" must be repeated, following the instructions contained in the corresponding sections. If the door is opened to the unit during the delay period, the countdown will stop. All of the wash cycle set to reverse time function, we may in focus stat circulate time. Cancelling or modifying a cycle Load for 12 Standard Settings (for IEC-EN 50242 tests) A cycle that is underway can only be modified if it has only been running for a short time. Otherwise, the detergent may have already been used, and the appliance mayhave already drained the wash water. If this is the case, the detergent dispenser must be refilled (see the paragraph entitled, "Loading the Detergent"). To modify a cycle that is already underway, press the ON/OFF button (B), all of the settings will be cancelled. To set a new cycle, follow the instructions contained in the paragraph entitled "Setting and starting a wash cycle". 30g Economic, fast cycle to be used on not very dirty dishes right af- Short wash at 40 Cold rinse . . How to Keep Your Dishwasher in Shape Rapid Wash ter they are used. No drying cycle. 15g After Every Wash After every wash, turn off the water supply to the appliance and leave the door slightly ajar so that moisture and odours are not trapped inside. Moving the Appliance If the appliance must be moved, try to keep it in the vertical position. [. . . ] Use the special plastic support that comes with the appliance (see Fig. 2). The free end of the hose must be at a height between 40 and 100 cm and must not be immersed in water. Attention: The special plastic hose support must be solidly fastened to the wall to prevent the drain hose from moving and allowing water to spill outside the drain. Electrical Connection After making sure that the voltage and frequency values for the current in the home correspond to those on the rating plate (located on the stainless steel inner door of the appliance) and that the electrical system is sized for the maximum voltage on as long as it does not exceed a temperature of 60 . In this case, the wash cycle time will be shortened by about 15 minutes and the wash efficiency slightly reduced. [. . . ]