User manual HAIER DW12-CBE6

[. . . ] The dispenser must be refilled before the start of each wash cycle following the instructions provided in the "Wash Cycle Table" . The detergent dispenser is located on the inside panel the door. GB Salt The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form on the dishes and utensils. The appliance is equipped with a special softener that uses a salt specifically designed to eliminate lime and minerals from the water. Adjusting Salt Consumption The dishwasher is designed to allow for adjusting the amount of salt consumed based on the hardness of the water used. This is intended to optimize and customize the level of salt consumption so that it remains at a minimum. [. . . ] The start time for the wash cycle can be delayed for 2, 4, 6, 8, 10 or 12 hours. Each time the button is pressed, the "D" light will come on indicating the length of the delay. After selecting the delay time, the wash cycle can be set, as explained in "Starting a wash cycle. . . " Close the door and at this point the delay period will come on to count down. At the end of the delay time, the indicator will turn off blinking and the cycle will start. Load for 12 Standard Settings (for IEC-EN 50242 tests) will blink in succession, at the same time the dishwasher will emit a acoustic sound. Choose the wash cycle you feel is most appropriate for the type of dishes that need washing (consult the wash cycle table con- 1 2 tained in this manual, especially when first using the appliance). Close the door and then the wash cycle has begun and cannot be modified. If necessary, read the paragraph entitled, "Cancelling or modifying a cycle while underway. "The end of the cycle 3 4 Fig. A fig. B will be signalled by six acoustic sound, and the indicator light "M" will turn off. Cancelling or modifying a cycle while underway. . . Premise: A cycle that is underway can only be modified if it has only been running for a short time. Otherwise, the detergent may have already been used, and the appliance may have already drained the wash water. If this is the case, the detergent dispenser must be refilled (see the paragraph entitled, "Loading the Detergent"). NOTE: During the delay period, none of the settings can be modified. a) If necessary, they can be cancelled by pressing press the ON-OFF button "A" located on the control panel. b) If the door is opened during the delay period, the clock will stop the countdown. It will start again when the door has been closed. How to Use the Upper Rack The upper rack is designed to hold more delicate and lighter dishware, such as glasses, coffee and tea cups and saucers, as well as plates, small bowls and shallow pans (as long as they are not too dirty). - Position the dishes and cookware so that they do not get moved by the spray of water. The upper rack can be adjusted for height by using the knobs located on the sides of the rack itself (see Fig. B). fig. C fig. D To change the cycle currently underway, open the door and press the ON-OFF button "A", follow the instructions contained in the paragraph entitled, "Starting a wash cycle ing a Wash Cycle. " ", "Setting and Start- Wash Cycle Adjustment Buttons Shelf Lean tall glasses and those with long stems against the shelf-not against other items to be washed. Standard daily cycle. 30g Remove the plug Before cleaning or performing maintenance, always remove the plug from the socket. Do not run risks. Moving the Appliance If the appliance must be moved, try to keep it in a vertical position. If absolutely necessary, it can be positioned on its back. Pre-wash with cold water. Economic, fast cycle to be used for items which are sensitive to higher. Run immediately after K pots and pans without dried on residue. No solvents or Abrasive Cleaning Products 25+5g Light Wash (IEC-EN50242) ERF To clean the exterior and rubber parts of the dishwasher, do not use solvents or abrasive cleaning products. To remove spots or stains from the surface of the interior, use a cloth dampened with water and a little while vinegar, or cleaning product made specifically for dishwashers. Seals One of the factors that cause odors to form in the dishwasher is food that remains trapped in the seals. Periodic cleaning with a damp sponge will prevent this from occurring. Wash at 60 Hot rinse. [. . . ] If the water pipes are new or have not been used for an extended period of time, let the water run to make sure that the water is clear and free of impurities. If this precaution is not taken, there is a risk that the water inlet can get blocked and damage the appliance. fig. 1 Drain Hose Connection Insert the drain hose into a drain pipe with a minimum diameter of 4cm, or let it run into the sink, making sure to avoid bending or crimping it. Use the special plastic support that comes with the appliance (see fig. 3). The free end of the hose must be at a height between 40 and 100 cm and must not be immersed in water. The Dishwasher Does Not Load Water Have you checked whether: - the water is turned on and the hose is connected properly; - the water supply to the house is on and has sufficient pressure; - the water supply hose is crimped or bent; - the filter for the water supply hose is clogged. and/or the problem persists, contact the nearest authorised service centre and provide them with the following information: - the nature of the problem; - the model type number (Mod. . . ) And the serial number (S/N. . . ), which are indicated on the plate located on the side of the inner part of the door. The Dishes Are Not Clean Have you checked whether: - the water is turned on and the hose is connected properly; - the water supply to the house is on and has sufficient pressure; - the water supply hose is crimped or bent; - the filter for the water supply hose is clogged. Never call on unauthorised technicians and refuse to allow parts to be installed that are not original spare parts. Hot Water Connection The water supply to the appliance can also be connected to the house's hot water line (centralised system, heating system), as long as it does not exceed a temperature of 60 . fig. 3 Attention: The special plastic hose support must be solidly fastened to the wall to prevent the drain hose from moving and allowing water to spill outside the drain. In this case, the wash cycle time will be shortened by about 15 minutes and the wash efficiency slightly reduced. [. . . ]