User manual HAIER BKD60SS

[. . . ] - The appliance is not intended for use by young children or inform persons without supervision. - Young children should be supervised to ensure that they do not play with the appliance. - Keep detergents out of the reach of children, who must also be kept away from the dishwasher when it is open. - This appliance cannot be installed outdoors, not even if the area in which it is installed is covered by a roof; it is also very dangerous to leave it exposed to the rain and elements. Close-up View (control panel) A B C D E F ON-OFF Button ON-OFF Light 1/2 load Button 1/2 load indicator light Delay select Button Display delay time . 1. G H I J K L Cycle select button Cycle indicator light Start/Pause button Low Rinse Aid Indicator Light Low Salt Indicator Light Handle For Opening Door GB Close-up View (Interior) A B C D E Upper Rack Rack Height Adjustor Top Spray Arm Lower Rack Bottom Spray Arm F G H I Washing Filter Detergent and Rinse Aid Dispenser Salt Container Cap Third Sprayer Technical characteristics Width Depth Height Capacity Mains water pressure Power voltage Total absorber power 60cm 60cm 85cm 12 standard place settings 0. 03-0. 6MPa 220-240V~ 50Hz 2150W GB . 2. Salt Salt The hardness of the water varies from place to place. [. . . ] - The silverware basket can be doubled (see Fig. A) so that only one section may be used when the silverware load is light. This also makes space for additional pots and pans, and it can also be placed in the upper rack. - Silverware should be placed in the silverware basket with the handles at the bottom; if the rack has side baskets, the spoons should be located individually into the appropriate slots. Especially long utensils should be placed in the horizontal position at the front of the upper rack. Load for 12 Standard Settings How to Use the Upper Rack The upper rack is designed to hold more delicate and lighter dishware, such as glasses, coffee and tea cups and saucers, as well as plates, small bowls and shallow pans (as long as they are not too dirty). - Position the dishes and cookware so that they do not get moved by the spray of water. 1 2 3 The upper rack can be adjusted for height by using the knobs located on the sides of the rack itself (see Fig. B). 4 Fig. A Fig. B . 5. GB Turning on the Appliance Starting a wash cycle After having completed all of the installation steps in the preced- Setting the Wash Cycle with a Delayed Start Time ing paragraphs, turn on the water all the way and press the ON- Premise: After selecting the wash cycle as indicated in the paraOFF button (A) located on the control panel. The "B" indicator graph entitled, "Setting and Starting a Wash Cycle. . . " the delay light will come on. wait a few seconds before programming the setting for the cycle. Setting and Starting a wash Cycle Select the desired cycle by pressing the selector button (G). Each By pressing the "E" button (see close-up view-'Control panel") time the button is pressed, one of the "H" cycle indicator lights will the start of wash cycle can be delayed for between 1 to 9 hours. Choose the wash cycle you feel is most Each time the button is pressed, the display (F) will show the appropriate for the type of dishes that need washing (consult the number of hours for the delay period. Choose the amount of wash cycle table contained in this manual, especially when first time desired. When the appliance is started with "I" button, a short using the appliance). acoustic signal will sound and the delay time on the display will Press the Start/Pause button (I), and after a few seconds a short blink, indicating that the countdown has begun. acoustic sound will indicate that the wash cycle has begun and can no longer be changed. If necessary, read the paragraph enAfter the time has lapsed, the cycle will start. titled "Cancelling or modifying a cycle while underway. . . " Cancelling or modifying a cycle while underway Premise : A cycle that is underway can only be modified if it has only been running for a short time. Otherwise, the detergent may have already been used, and the appliance mayhave already drained the wash water. If this is the case, the detergent dispenser must be refilled (see the paragraph entitled, "Loading the Detergent"). To modify a cycle that is already underway, press the ON-OFF button (A), then all of the settings will be cancelled. NOTE: a) During the delay period, it is preferable not to change any of the settings. If it is necessary, all of the settings must be cancelled by pressing the ON-OFF button (A) to indicate that all of the settings have been cancelled. At this point, all of the steps for "Setting the Wash Cycle with a delayed Start Time" and "setting and Starting a Wash Cycle" must be repeated, following the instructions contained in the corresponding sections. b) If the door is opened during the delay period, the indicator will If you forget to load some of the dishes blink and acoustic signal will sound, and the countdown will stop. The wash cycle can be interrupted by pressing the Start/Pause It will begin again when the door is closed . [. . . ] The free end of the hose must be at a height between 40 and 100 cm and must not be immersed in water. Hot Water Connection The water supply to the appliance can also be connected to the house's hot water line (centralised system, heating system), as long as it does not exceed a temperature of 60 . In this case, the wash cycle time will be shortened by about 15 minutes and the wash efficiency slightly reduced. The connection must be made to the hot water line following the same procedures as those for the connection to the cold water line. Fig. 2 Anti-Flooding Protection The dishwasher is equipped with a system that stops the supply of water in the event of a problem with the water supply hose, or leaks within the unit, in order to prevent damage to your home. If for any reason the box containing the electrical components happens to get damaged, remove the plug for the appliance from the socket immediately. [. . . ]