User manual HAIER AF18AS1ERA

[. . . ] Please be subject to the actual produce purchased the above picture is just from your reference ON/OFF button Push once to start operation, push once again to stop it. RESET button When the remote controller appears abnormal, use a sharp pointed article to press this button to reset the remote Healthy function is not available for some units. Be sure that the loading is in line with the" + "/"-"; Load the battery, then put on the cover again. Please be subject to the actual produce purchased the above picture is just from your reference The distance between the signal transmission head and the receiver hole should be within 7m without any obstacle as well. [. . . ] Setting so that room temperature won't be too high for your sleep. All the products are in conformity with the following European provision: - Low Voltage Directive 73/23/EEC - Low Voltage Directive 2006/95/EC -Electomagnetic CompatibilitY 89/336/EEC -Electomagnetic CompatibilitY 2004/108/EC The products are fulfilled with the requirements in the directive 2002/95/EEC of the European parliament and of council on the Restriction of the use of Certain Hazardous Substances in Electrical and Electronic Equipment (EU RoHS Directive) In accordance with the directive 2002/96/CE of the European parliament, herewith we inform the consumer about the disposal requirements of the electrical and electronic products. This means that electrical and electronic products shall not be mixed with unsorted household waste. Do not try to dismantle the system yourself : the dismantling of the air conditioning system, treatment of the refrigerant, of oil and of other part must be done by a qualified installer in accordance with relevant local and national legislation. air conditioners must be treated at a specialized treatment facility for reuse , recycling and recovery. By ensuring this product is disposed of correctly, you will help to prevent potential negative consequences for the environment and humen health. please contact the installer or local authority for more information. Battery must be removed from the remote controller and disposed of separately in accordance with relevant local and nationl legislation. The unit operaters in corresponding sleep mode adapted to the automatically selected operation mode. Set the wind speed change when sleeping If the wind speed is high or middle before setting for the sleep, set for lowing the wind speed after sleeping. Before inserting power into receptacle, check the voltage without fail. A receptacle shall be set up in a distance where the power cable can be reached. Place, robust not causing vibration, where the body can be supported sufficiently. Place, not affected by heat or steam generated in the vicinity, where inlet and outlet of the unit are not disturbed. Place, possible to drain easily, where piping can be connected with the outdoor unit. Place where the distance of more than lm from televisions, radios, wireless apparatuses and fluorescent lamps can be left. In the case of fixing the remote controller on a wall, place where the indoor unit can receive signals when the fluorescent lamps in the room are lightened. Attention must be paid to the rising up of drain hose More than 60 cm more than 10cm Make a hole of 70 mm in diameter, slightly descending to outside the wall Install piping hole cover and seal it off with putty after installation Coat the flaring seal face with refrigerant oil and connect pipes. Cover the connection part with heat insulation materials closely, and make sure fixing with adhesive tape Hold the front panel by the tabs on the both sides and lift it until it stops with a click. Indoor/outdoor electric cable and drain hose must be bound with efrigerant piping by protecting tape. Cut away, with a nipper, the lid for piping according to the piping direction and then bend the pipe according to theposition of wall hole. Connect beforehand the indoor/outdoor electric cable, and then pull out the connected to the heat insulation of connecting part specially. [. . . ] PROHIBITION Do not pour water onto the unit for cleaning PROHIBITION Do not place animals or plants in the direct path of the air flow PROHIBITION Do not place any objects on or climb on the unit. Cause or check points When unit is stopped, it won't restart immediately until 3 minutes have elapsed to protect the system. When the electric plug is pulled out and reinserted, the protection circuit will work for 3 minutes to protect the air conditioner. During unit operation or at stop, a swishing or gurgling noise may be heard. [. . . ]