User manual HAIER ADP8152

[. . . ] - After removing the packing, check to make sure that the appliance is not damaged. If in doubt, contact a qualified professional. - The dishwasher must only be used by adults for the washing of household dishes and cooking utensils. - Fundamental rules to follow when using the appliance: * Do not use extension cords or multiple sockets; * During installation, the power supply cord must not be exces sively or dangerously bent or flattened; * If the appliance is not operating properly, or, maintenance must be performed, disconnect the appliance from the power supply. CONTENTS Electrical Safety Instruction Installation Troubleshooting Cleaning and Special Maintenance Wash Cycle Table How to Keep Your Dishwasher in Shape Energy Saving Tips Wash Cycle adjustment Buttons Turning on the Appliance Loading the Dishwasher Detergent and Rinse Aid Salt Close-up View (Interrior) Close-up View (control panel) Safety Is a Good Habit to Get Into 1 1 2 3 4 5 R 1 2 Close-up View (Control Panel) ABCD 5 ON OFF 1 2 3 S 6 6 7 8 8 9 9 10 12 1 2 3 4 5 4 I HG ON-OFF Light ON-OFF Button Low Salt Indicator Light F E A B C D E Low Rinse Aid Indicator Light Knob For Selecting Program F G H I . 1. Handle For Opening Door "Eco" Button "HALF LOAD" Button "RAPID"Button Close-up View (Interrior) Salt Salt The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form on the dishes utensils. [. . . ] If drops of water remain on the dishes or spotting occurs, the dosage adjustor should be turned to a higher setting. If the dishes have white streaks, turn the dosage adjustor to a lower setting. B C F How to Use the Upper Rack The upper rack is designed to hold more delicate and lighter 1 2 dishware, such as glasses, coffee and tea cups and saucers, as well as plates, small bowls and shallow pans(as long as they are not too dirty). Position the dishes and cookware so that they do not get moved by the spray of water. B) 3 4 C Notice:To facilitate closing the cover, remove any excess detergent on the edges of the dispenser. Fig. A Fig. B . 4. . 5. Turning on the Appliance Wash Cycle Table Starting a wash cycle - Make sure that the plug for the appliance is inserted into the wall socket. - Load the dishwasher (see the section entitled, "Loading the Dishwasher"). - Pour in the detergent (see the section entitled, "Salt, Dergent and Rinse Aid"). - Turn the knob located on the right of the control panel in the clockwise direction until the number or symbol for the cycle set ting is aligned with the reference mark(see the section entitled, "Wash Cycle Table"). - Press the ON-OFF botton, and the ON-OFF light will turn on. At this point, the wash cycle will begin. 4 Wait a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they are still hot and more susceptible to breakage. They will also dry better. 5 1 2 3 Cycle Eco Button RAPID Button Cycle Selection Information Desciption of Cycle Detergent Rinse Aid Normal Wash 6 Pre-wash with hot water. Very dirty dishes, pots and Extended wash at 65 pans. (not to be used with Rinse with cold water. Normally dirty dishes, pots Extended wash at 55 and pans. Standard daily Rinse with cold water. Normally dirty dishes, pots Extended wash at 65 and pans without dried on Rinse with cold water. 15g "1/2 load" Button This button(see "close-up View - Control Panel", letter"H") make it possible to wash dishes using only the upper rack if there are not enough dishes for a full load. This will allow you to save on water and eletrical energy. "Rapid" Button This button(see "close-up View - Control Panel", letter "I") , when pressed with wash cycle 4(glassware) make it possible to run the wash cycle at a lower temperature (50 ) and eliminates the drying phase. . 6. . 7. Energy Saving Tips Cleaning and Special Maintenance Filter Assembly - It is important to try and run the dishwasher when it is fully loaded to save on energy. In order to prevent odors from forming and food from caking onto the dishes, you can run the hold cycle. - Choose the right wash cycle: the choice of cycle depends on the type of dishware, cookware and utensils being washed and how dirty they are. - Use the right amount of detergent: if you use too much detergent, the result will not be cleaner dishes, but, rather, a greater nega tive impact on the environment. - There is no untility in rinsing dishes , cookware and untensils before placing them in the dishwasher. For best performance and results, the filter assembly must be cleaned. The filter efficiently removes food particles from the wash water, allowing it to be recirculated during the cycle. For this reason , it is a good idea to remove the larger food particles trapped in the filter after each wash cycle by rinsing the"A"semi-circular filter and cup under running water. To remove the filter assembly, pull on the cup handle in the upward direction. The entire filter assembly (made up of the "A" semicircular filter and the"B" fine filter)should be cleaned at least once a month. To clean the filter and the fine filter, use a cleaning brush . Then, reassemble the filter parts as shown in the figures below and reinsert the entire aseembly in the dishwasher, positioning in its seat and pressing downward. The dishwasher must not be used without the filters. Improper replacement of the filters may reduce level of the appliance and damage dishes and utensils. A Cleaning the Spray Arms It may happen that food particle become encrusted on the sprayer arms and block the hole (see "Close up view [interior]", letters CF ). Check the sprayer arms periodically and clean them when needed. B How to Keep Your Dishwasher in Shape Troubleshooting After Every Wash After every wash, turn off the water supply to the appliance and leave the door slightly ajar so that moisture and odors are not trapped inside. Moving the Appliance If the appliance must be moved, try to keep it in the vertical position. It may occur that the dishwasher does not function or does not function properly. Before calling for assistance, Iet us see what can be done first:have you forgot to press one of the buttons or to perfom an essential operation? The Dishes Are Not Clean Have you checked whether: - the water is turned on and the hose is connected properly; - the water supply to the house on and has sufficient pressure; - the water supply hose is crimped or bent; - the filter for the water supply hose is clogged. Remove the Plug Before cleaning or performing maintenance, always remove the plug from the socket. Do not run risks. Seals One of the factors that cause odours to form in the dishwasher is food that remains trapped in the seals. Periodic cleaning with a sponge will prevent this from occuring. The Dishwasher Does Not Start Have you checked whether: - the plug is pushed into the socket correctly; - the power is on in the house; - the door is closed properly; - the ON-OFF switch is on "ON"; - the water supply is turned on. The Dishwasher Does Not Drain Have you checked whether: - the drain hose is crimped or bent. Lime Deposits or a White Film Form on the Dishes Have you checked whether: - the lid to the salt container is closed properly; - the rinse aid dosage is correct. [. . . ] b) The unit must be correctly installed and operated in accordance with the manufacturer's instructions and used for normal domestic purposes. c) The guarantee does not cover accidental damage, misuse or alterations which are likely to affect the units. d) The guarantee is invalid is tampered with, or repaired by any unauthorised person. Refit the fuse cover BLUE BROWN YELLOW & GREEN "NEUTRAL" (N) "LIVE" (L) "EARTH" (E) Procedure when Reporting A Fault 1. [. . . ]