User manual HAIER 40-MS

[. . . ] Do not decompose, repair or alter the machine by yourself. Do not put any hot or heavy items ( such as the kettle with hot water ) on the washing machine. Do not wash laundries with volatile materials (such as thinner, petrol etc. ). l Petro Thinner Handicapped or children without care shall not use the machine. Keep the machine away from direct sunlight and heat source like the heater. To protect your laundries and washing machine, please take out all of the coins, buttons, sand, hairpin and other foreign materials before washing. Please check if the water faucet is open, and if the connection of the water inlet pipe is proper. It is suggested to use foamless washing powder. 3 Installation and adjustment Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine. Install the lint filter After opening the package, please take out the lint filter from the document bag, install it to the overflow filter of the wash tub. See to the figure. Overflow filter Lint filter The drainage shall be smooth with the drain hose. 1. The height of the drain hose shall be less than 1. 2m , or the drainage will not be smooth enough and cause incomplete drainage. <1. 2m 2. Do not step on or press the drain hose. 4 How to change the direction of the drain hoses Figure 1 indicates the ex factory installation position of the drain hose. [. . . ] For the parts with heavy soil, please apply detergent on them in advance, which can make it easier to remove the soil. For those laundries that may get lint ball and those with long fur, turn it over before putting in. Do not put those laundries polluted by chemicals into the washing machine directly. 6 The musts in washing The capacity of washing and spinning of the machine refer to the largest weight of the standard laundries under dry condition that can be washed or spinned in one time. Laundries quantity in one washing cycle shall be lower than the rated capacity. The thickness , size , type of the cloth will influence the actual washing capacity. It is suitable to put in reasonable amount of laundries and the laundries can be turned round in washing for one time washing. Do not select " Maximum " water level for laundries less than 2. 4kg, so as to avoid splashing of water. It is suggested not to use high sudsing detergent. Usage of the detergent How to use the whitener Fill water to decided level. Avoid using whitener on laundries with color or pattern as they are prone to lose color. Refer to the user's manual for the usage and quantity of the whitener. For powder whitener, please dissolve it before using. How to use the washing powder Direct dissolved in the machine: 1. Fill small quantity of water. The instant dissolving of the washing powder: 1. Prepare warm water of 30 C and a container. Please refer to the instruction of the washing powder for the detail dosage. 7 Washing sequence Wash timer Water inlet (To set to below 2 minute, first set to 5 minute then turn it back. it can increase the service life of the timer). OFF Wash selector (standard current, soft current) Spin timer (to set to below 1 minute, first set to 2 minute then turn it back. it can increase the service life of the timer). OFF STANDARD SOFT DRAIN WASH TIMER WASH SELECTOR SPIN TIMER Wash 1. Fill the water and add the dissolved washing powder to make the water level reach the preset position. (Figure 1) Run washing program for some time to stir and dissolve the powder completely. (Figure 2) 4. Select the washing time Select the washing time according to the laundries. [. . . ] Clean the lint Put it in water and clean while it is still wet. (See to Figure 2) Figure 1 3. Install the lint filter After cleaning, insert the bottom Figure 2 of the lint filter ( marked with "down side") into the overflow filter , then push the upper part of the filter in ( marked with " up side "). (See to Figure 3) Figure 3 Cleaning the overflow filter Too much lint on the overflow filter will influence the normal usage of the machine. claw As indicated in the figure, nip the elastic fixing claw and pull it to the direction of the arrow to take it off. 1 10 Cleaning the overflow filter 2. [. . . ]