User manual HAIER 34P9B-T

[. . . ] Inspect and remove any remaining packaging, tape and printed material before turning on the water dispenser. Note: Allow the water dispenser to stand in an upright position for at least 12 hours before turning on the power. To ensure that your water dispenser works at the maximum efficiency it was designed for, you should install it in a location where there is proper air circulation and electrical connections. ⷠThe following are the recommended clearances around the water dispenser. [. . . ] Lift up the water bottle and quickly place it into the water receptacle. DO NOT plug in the water dispenser until you have checked that water flows out of both faucets when the hot and cold water release levers are pressed. Check that water flows out by pressing both the hot and cold water faucets one at a time. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. This appliance is equipped with a cord containing a grounding wire and a grounded plug. The plug must be inserted into an outlet that is properly installed and grounded. ⷠImproper use of the plug may result in the risk of electric shock. ⷠConsult a qualified electrician or service technician if the grounding instructions are not completely understood or if in doubt as to whether the appliance has been properly grounded. This appliance must be plugged into a 15Amp, 115 Volt, 60Hz GROUNDED OUTLET. Note: Where a standard two-prong outlet is encountered, it is the personal responsibility and obligation of the consumer to have it replaced with a properly grounded three-prong outlet. POWER INTERRUPTIONS Occasionally, there may be power interruptions due to thunderstorms or other causes. When setting the heating temperature, additional bars will be added as you increase the heating from 190°F (Min) to 203°F (Max). When setting the cooling temperature, additional bars will be added as you increase the cooling from 50°F (Min) to 43°F (Max). If nothing is pressed for 8 seconds the display will automatically exit the Set Function This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. ⷠDo not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer. Do not use electrical appliances inside the food storage compartments of appliance, unless they are of the type recommended by the manufacturer. ⷠTo avoid a hazard due to instability of the appliance, it must be fixed in accordance with the instructions. Caution: Before using any cleaning product, always read and follow the manufacturer's instructions and warnings to avoid personal injury and/ or product damage. Note: It is best to clean the dispenser and its surrounding area when replacing the empty bottle with a new one. This way you can move the unit easily without the weight of the bottle. Before cleaning, place a dust cover on top of the water guard to prevent dust and debris from going into the dispenser while cleaning. ⷠPrepare a cleaning solution of 3-4 tablespoons of baking soda mixed with warm water. [. . . ] if water dispenser operation is noisy: · Make sure the water dispenser sits on a level surface. If the dispenser is noisy after its first use, unplug it for half an hour and try again. if the condenser becomes too hot: · When the compressor is working, it is normal for the condenser to be hot. If you are concerned that the temperature is too high, check to see that there is enough room around the water dispenser to allow proper ventilation. [. . . ]