User manual H2O AUDIO OCEANIC DV

[. . . ] NOTE: The speakers are rigidly fixed to the housing and should not be disassembled from the housing for any reason. FCC CERTIFICATION: THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE, RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. Note: This equipment has been tested and found to comply with the limits for a Class B digital service, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Check the O-ring for hair, sand, lint, or other debris and wipe clean as necessary. If the O-ring is cut or cracked it must be removed and replaced with a new O-ring. Uniformly spread a bead of grease on the O-ring until there is a thin film covering the complete surface. CAUTION: Only use the O-ring grease provided with your housing. 4. Before replacing the O-ring, visually inspect the groove in the lid and the contact surface for hair, sand, lint, or other debris and wipe clean as necessary. Also, check the contact surfaces scratches, blemishes, or other imperfections. It is very possible the housing will flood and damage the electronics. Install the O-ring with the flat side down; making sure that it is seated uniformly, with no twists or loose areas. Be careful not to stretch the O-ring unnecessarily. GENERAL STORAGE PROCEDURES: For long-term storage, remove O-ring and store out of direct sunlight. If the O-ring will not be used for a long period of time, remove from it the housing and store in a plastic bag out of direct sunlight. If the Oring is stored in a dry environment for a long period of time, it will develop cracks and become unusable. Always remember to reinstall and lubricate the main housing O-ring before next use. Do not expose the housing to extreme heat, such as the inside of a hot car, or in hot direct sunlight, such as a beach, or boat deck. CAUTION: Do not store housing in following environments: * Solvents or other chemical fumes * High humidity * High Ozone * Extreme temperature fluctuations Storage in such conditions may lead to housing damage and leakage. Then completely dry the entire exterior of the system using a clean soft cloth. Strong detergents, soaps, and chemicals MUST NEVER be used to clean the system. If you must use a soap, it should be a very diluted. HOUSING OPERATIONS: Button 1: MP3 ON/OFF/Play/Stop Button 3: Mode Lever 1: Navigation Button 2:Memory/EQ Open the Housing STEP 1: Pull out the Tab STEP 2: Rotate the Dial counterclockwise CAUTION: If the housing has been subjected to pressure and become `tighter' and more difficult to open than usual, in this case, rotate the dial a little more strongly than usual. FORWARD BACKWARD Volume DOWN + O N CLOS PE Volume UP E TAB Button 5: Menu Closing the Housing STEP 1: -Rotate the Dial Clockwise until both halves of the housing are fully closed. If you feel resistance, check to make sure the MP3 player and O-Ring are properly positioned. Button 4: Amplifier Power ON/OFF CAUTION: This device provides powerful amplification of the audio signal beyond the normal output of standard stereo devices. This system is specifically engineered for underwater use to enhance fidelity at depth. After using the product, lower the volume to zero before turning the device on again. The MP3 player Volume level MUST be at ZERO before turning the Amplifier Power ON Lever 2: Volume WARNING: The MP3 player volume MUST be at ZERO before turning the Amplifier Power ON. This system is equipped with a Stereo Amplifier Module located within the housing. The Amplifier is engineered to provide output power needed at depth to maintain high fidelity and clarity of the audio. INSTALLING & REPLACING AMPLIFIER BATTERY: STEP 1: WIPE EXTERIOR AND MAKE SURE IT IS DRY STEP 2: TURN OFF THE AMPLIFIER STEP 3: OPEN HOUSING CAUTION: Completely dry the inside of any moisture STEP 4: REMOVE AND UNPLUG THE MP3 PLAYER INSTALLING THE MP3 PLAYER: CAUTION: Before opening be sure to rinse the sealed system in fresh water. [. . . ] WARRANTY LIMITATIONS: Warranty does not extend to cover damage from accident, abuse, tampering, lack of maintenance, theft, or loss. Service or modifications by anyone other than an Authorized DES agent will void the warranty. DES will not be responsible for recovery or replacement of the product in the event of loss or theft. DES, its Authorized International Distributors, and Authorized Dealers make no other warranties, either express or implied or orally, or in writing, with respect to any other warranty coverage except those expressly stated within the preceding paragraphs. [. . . ]