User manual H2O AUDIO IDIVE300

[. . . ] Lubricating the O-ring does not improve the seal and only a small amount of silicone grease is necessary to lubricate the O-ring. Use only the silicone grease provided to lubricate the O-ring. 4 3 IT IS EXTREMELY IMPORTANT YOU ENSURE THE O-RING IS PROPERLY SEATED IN ITS TRACK AND IS FREE OF DEBRIS BEFORE EACH USE. FAILURE TO DO SO MAY CAUSE DAMAGE TO OR DESTROY YOUR IPOD. Prior to use verify: 1. The O-ring is lightly lubricated and seated within the track in the lid. [. . . ] Batteries of the iDive300 case are running low ­ change or recharge them soon. Mode Button Note: The current firmware release does not support the "Photo" mode on iPod models with a touch-screen interface For Mask Strap Mounting: Feed mask strap through the slits in each slot of the clip. To Remove Mask Clip: For touch-screen iPod models it's necessary to use the mode button to cycle between the various iPod menus/modes (i. e. The mode button does not function with scroll-wheel controlled iPod models. Starting from the Audio menu, press the "Mode" button - this will transfer the user to the "Photo" menu (not currently supported). Press the "Mode" button again to transfer to the "Video" menu. Press the "Mode" button again to transfer to the "Photo" menu (not currently supported). To return to the "Audio" menu, press the "Mode" button one additional time. Speakers iDive300 speakers feature specially designed clips for attachment to mask straps. The mask clips are removable for users who wish to put the speakers inside a diving hood or under their mask strap. 13 IX. General Storage Procedures For long-term storage, store in a cool dry place out of direct sunlight. Do not expose the case to extreme heat, such as the inside of a hot car, or in direct sunlight, such as on a beach, or boat deck. CAUTION: The case is susceptible to internal condensation with extreme temperature fluctuations. When used in temperatures below freezing, frost will appear on the interior of the case. 14 CAUTION: Do not store case in the following environments: * Solvents or other chemical fumes * High humidity * High Ozone * Extreme temperature fluctuations Storing the case in these conditions may lead to a damaged case, causing it to leak. Completely dry the entire exterior of the system using a clean soft cloth. Strong detergents, soaps, and chemicals MUST NEVER be used to clean the system. Contact Us Customer Support is available Monday to Friday 9AM -5PM PT. web: www. h2oaudio. com Phone: 1. 800. 708. 6080 or 858. 623. 0339 Fax: 858. 225. 0815 Email: Support@h2oaudio. com XI. FCC Certification: This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference and (2) This device must accept any interference, received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital service, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] To receive an RA number, go online to www. h2oaudio. com/returns. php and follow the simple instructions on how to return a product. A copy of the original sales receipt and a copy of the owner's portion of the warranty card must accompany all correspondence regarding the equipment covered by this warranty agreement or in direct reference to this warranty. 19 20 Q: Why is the Red LED flashing?A: The iDive300 is designed to measure battery-life of the 3-AA batteries that are used to power the "Made for iPod" connection electronics and the power amplifier. The Red LED will start to flash when the batteries have approximately 25% charge remaining. [. . . ]