User manual GTO PRO-SW 1500 DUAL

[. . . ] Our corporate headquarters and state of the art manufacturing facility is located in Tallahassee, Florida. One of our highest priorities is to provide outstanding technical service to our customers. Therefore, if you have any questions or require any technical assistance, please call our toll free line 800-543-1236 or 850-575-4144 and ask to speak to one of our technicians. Prior to installing your 1500 Dual Gate Operator Connection Kit, please read this manual thoroughly. [. . . ] SLAVE closes 1st, MASTER closes 8 seconds later MASTER and SLAVE simultaneously open and close. 4. DIP switch #4: (See main manual for additional details) OFF: Pulse output at `AUX OUT' terminal when gate is opening. ON: Continuous output at `AUX OUT' terminal when gate is moving. 3 RED BLK 18VAC 18VAC 5 Setting SECOND arm to operate as SLAVE arm: 1. The SLAVE arm should be at the fully retracted position at this time. Gate Operator in the RERACTED POSITION 2. The receiver is not operational if the arm is operating in SLAVE mode. Set DIP switch #2 and #3 (MODE 1 and MODE 2) to the `OFF' position (factory default). This setting will set the arm to operate in SLAVE mode if there is a MASTER arm present. DIP switch #4: (See main manual for additional details) OFF: Pulse output at `AUX OUT' terminal when gate is opening. ON: Continuous output at `AUX OUT' terminal when gate is moving. 15 1 2 Disconnect Receiver Wires PULL-PUSH CHARGING MODE1 POWER MODE2 LOCK/BEACON 18VAC SOLAR PANEL LINK GRN EXIT SAFETY EDGE AUX OUT COMMON CYCLE RCVR 6 Setting the CLOSE LIMIT (Pull to open installation only): FF 1. Press the remote (assuming that the remote has already been `learned'). The SLAVE arm or both arms (depending on your sequence setting) should be closing. Press the remote again to stop the gate at the desire closed position. Note: whichever gate reached its desired closed position first that will be the first one to be programmed. If the SLAVE arm is stopped at the desired closed position, press the `SET LIMIT' on the SLAVE arm for 5 seconds. If the MASTER arm is stopped at the desired closed position, press the `SET LIMIT' on the MASTER arm for 5 seconds. Press the remote again and allow both gates to return to the fully opened positions. Repeat step 5 for the side that has not been programmed in the previous step. 4 RED BLK ON/O FF STATUS MIN MAX STALL FORCE OFF 120 CLOSE TIME SET LIMIT LEARN REMOTE ON PULL-PUSH MODE1 MODE2 LOCK/BEACON RF 3 4 ON 1 2 3 4 7 Setting the open limit (Push to open installation only): 1. Press the remote (assuming that the remote has already been `learned'). The SLAVE arm or both arms (depending on your sequence setting) should be opening. Press the remote again to stop the gate at the desire opened position. Note: whichever gate reached its desired opened position first that will be the first one to be programmed. If the SLAVE arm is stopped at the desired opened position, press the `SET LIMIT' on the SLAVE arm for 5 seconds. If the MASTER arm is stopped at the desired opened position, press the `SET LIMIT' on the MASTER arm for 5 seconds. [. . . ] or one of its authorized service centers will make any necessary repairs for a nominal fee. This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state. This warranty is in lieu of all other warranties, expressed or implied. NOTE: Verification of the warranty period requires copies of receipts or other proof of purchase. [. . . ]